Nissan Rogue (T33) 2021-Present Service Manual: C1071-01 Decel G Sensor

DTC Description

DTC DETECTION LOGIC

POSSIBLE CAUSE

NOTE:

Confirm if DTC is PAST or CRNT. If DTC is CRNT, proceed with Diagnosis Procedure. If DTC is PAST, clear the DTC. Do not replace the ABS actuator and electric unit (control unit) for a PAST DTC.

FAIL-SAFE

The following functions are suspended.

• VDC function

• TCS function

• Brake limited slip differential (BLSD) function

• Bake assist function

• Brake force distribution function

• hill start assist function

DTC CONFIRMATION PROCEDURE

PRECONDITIONING

If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always ignition switch OFF (Auto ACC function OFF) before conducting the next test.

GO TO 2.

CHECK DTC DETECTION

CONSULT

1. Ignition switch OFF (Auto ACC function OFF).

2. Start the engine.

   NOTE:

   Wait at least 10 seconds after starting the engine.

3. Perform self-diagnosis for “ABS”.

Is DTC “C1071-64” detected?

“CRNT” is displayed: Refer to Diagnosis Procedure.

“PAST” is displayed: Inspection End (Erase the memory of self-diagnosis results.)

To check malfunction symptom before repair: Refer to Intermittent Incident.

Confirmation after repair: Inspection End

Diagnosis Procedure

CHECK SELF-DIAGNOSIS RESULTS

CONSULT

Replace the ABS actuator and electric unit (control unit) even if other DTCs are displayed along with “C1071-64” in self-diagnosis for “ABS”.

Replace the ABS actuator and electric unit (control unit). Refer to Removal and Installation.