Nissan Rogue (T33) 2021-Present Service Manual: C0503 Wheel Speed Sensor

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / C0503 Wheel Speed Sensor

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
C0503 00

Left front wheel speed sensor

(Left Front Wheel Speed Sensor Circuit High) 		Diagnosis condition

  • Ignition switch ON

  • Battery voltage: 11 V
Signal CAN communication signal
Threshold When some DTC is detected in the VDC and via CAN communication is sent to the ECM
Diagnosis delay time 12 seconds or more

POSSIBLE CAUSE

  • Harness or connectors (Wheel speed sensor FL circuit is shorted.)

FAIL-SAFE

Engine Control System

Not applicable

Stop/Start System

Not applicable

DTC Confirmation Procedure

CHECK DTC

Perform the confirmation procedure for displayed DTC with VDC. Refer to below:

  • DTC C1061-12: Refer to DTC Description.

  • DTC C1061-13: Refer to DTC Description.

Is DTC detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

CHECK DTC

Perform the confirmation procedure for displayed DTC with VDC. Refer to below:

  • DTC C1061-12: Refer to Diagnosis Procedure.

  • DTC C1061-13: Refer to Diagnosis Procedure.

Is inspection result normal?

YES>>

INSPECTION END

NO>>

Repair or replace error-detected parts.

    C0502 Wheel Speed Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition C0502 00 Left front wheel speed sensor (Left Front Wheel Speed S...
    C0505 Wheel Speed Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition C0505 00 Left front wheel speed sensor (Left Front Wheel Speed S...

    Other materials:

    Dtc/circuit Diagnosis. B2428-46 Automatic Back Door Control Unit
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition B2428-46 Automatic back door control unit (Automatic back door control unit) Diagnosis condition All times Signal (terminal) — Threshold Automatic ...

    Power Supply and Ground Circuit
    Ecm Diagnosis Procedure CHECK THE BATTERY CABLE Turn ignition switch OFF. Check the battery cable for tightening enough. NOTE: Check the continuity between the battery cable and the battery terminal. Is the inspection result normal? YES>> GO TO 2 ...

    Information Display (combination Meter)
    Door Open Warning DESIGN/PURPOSEInformation display warns the driver that each door is open or is not fully closed. Symbol Message – SYNCHRONIZATION WITH MASTER WARNING LAMPSynchronization is applied.Refer to Master Warning Lamp.SYSTEM DIAGRAMSIGNAL PATH BCM transmits door switch ...