Nissan Rogue (T33) 2021-Present Service Manual: Brake Hold Relay

Nissan Rogue (T33) 2021-Present Service Manual / Cruise Control & Driver Assistance :: Driver Assistance System / Driver Assistance System :: Dtc/circuit Diagnosis / Brake Hold Relay

Component Inspection

CHECK STOP LAMP RELAY

Apply battery voltage to stop lamp relay terminals 3 and 4, and then check for continuity under the following conditions.

STOP LAMP RELAY Condition Continuity
Terminals
1 2 When the battery voltage is applied Yes
When the battery voltage is not applied No

Is the inspection result normal?

YES>>

Inspection End.

NO>>

Replace stop lamp relay.

    Front Camera Unit Heater
    Component Inspection CHECK FRONT CAMERA UNIT HEATER Check the resistance between the front camera unit heater terminals. Front camera unit heater Resistance [Ω] Terminal 1 4 7...
    Driver Assistance System. Symptom Diagnosis
    Driver Assistance System Symptoms Symptom Table Symptom Confirmation item Reference page All system displays do not display Combination meter On Board Diagnosis Function (12 inc...

    Other materials:

    Service Data and Specifications (sds)
    General Specifications BRAKE SYSTEMJAPAN PRODUCTION MODELS WITHOUT ProPILOT Assist 2.1Unit: mm (in) Front brake Cylinder bore diameter 60.33 (2.3752) Pad length × width × thickness 123.6 × 53.5 × 10.5 (4.87 × 2.106 × 0.413) Rotor outer diameter × thickness 296 × 26.0 ( ...

    Dtc/circuit Diagnosis. Thigh Support Motor
    Component Function Check CHECK FUNCTION CONSULT Ignition switch ON. Select “Thigh support motor” in “Active test” mode of “DRIVER SEAT”. Check thigh support motor LH operation. Test item Operation Thigh support motor Up Thigh support Upward Down ...

    Tcm
    Reference Value CONSULT DATA MONITOR STANDARD VALUE In CONSULT, electric shift timing or lock-up timing, i.e. operation timing of each solenoid valve, is displayed. Therefore, if there is an obvious difference between the shift timing estimated from a shift shock (or engine speed variation ...