Nissan Rogue (T33) 2021-Present Service Manual: Battery Saver

CONSULT Function (BCM - BATTERY SAVER)

DATA MONITOR

NOTE:

The following table includes information (items) inapplicable to this Nissan Ariya vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items.

Monitor item

[Unit]
Description

Door switch assist

[On/Off]
Indicates [On/Off] condition of front door switch RH.

Door switch rear right

[On/Off]
Indicates [On/Off] condition of rear door switch RH.

START SW

[On/Off]

NOTE:

This item is displayed, but cannot be monitored.

Door switch rear left

[On/Off]
Indicates [On/Off] condition of rear door switch LH.

Ignition switch

[On/Off]

NOTE:

This item is displayed, but cannot be monitored.

Door switch driver

[On/Off]
Indicates [On/Off] condition of front door switch LH.

Door lock and unlock switch (unlock)

[On/Off]
Indicates [On/Off] condition of UNLOCK signal from door lock/unlock switch.

Door lock and unlock switch (lock)

[On/Off]
Indicates [On/Off] condition of LOCK signal from door lock/unlock switch.
    Air Pressure Monitor
    CONSULT Function [BCM - AIR PRESSURE MONITOR] DATA MONITORNOTE: The following table includes information [items] inapplicable to this Nissan Ariya vehicle. For information [item...
    Bcm
    CONSULT Function (BCM - BCM) DATA MONITORNOTE: The following table includes information [items] inapplicable to this Nissan Ariya vehicle. For information [items] applicable to ...

    Other materials:

    Writing of Calibration Data
    Work Procedure DESCRIPTIONIf only the around view monitor control unit is replaced, the calibration data stored in the camera can be written to the around view monitor control unit by selecting "Camera Calibration" of "Work Support" mode in CONSULT.WORK PROCEDUREWRITE CALIBRATION DATA With C ...

    Symptom Diagnosis. Back Door Auto Closure Function Does Not Operate
    Diagnosis Procedure CHECK DTC WITH AUTOMATIC BACK DOOR CONTROL UNIT Check that DTC is not detected with automatic back door control unit. Is the inspection result normal? YES>> GO TO 2. NO>> Refer to DTC Index. CHECK OPEN SWITCH Check open switch. Refer to DTC Diagnosis Proce ...

    P0420 Three Way Catalyst Function
    DTC Description The ECM monitors the switching frequency ratio of air fuel ratio (A/F) sensor 1 and heated oxygen sensor 2.A three way catalyst (manifold) with high oxygen storage capacity will indicate a low switching frequency of heated oxygen sensor 2. As oxygen storage capacity decreases, ...