Nissan Rogue Service Manual: Basic inspection
- Diagnosis and repair work flow
- Additional service when replacing abs actuator and electric unit (control unit)
- Adjustment of steering angle sensor neutral position
- Calibration of decel G sensor
Wiring diagram
BRAKE CONTROL SYSTEM
Wiring Diagram
...
Diagnosis and repair work flow
Work Flow
DETAILED FLOW
1.INTERVIEW FROM THE CUSTOMER
Clarify customer complaints before inspection. First of all, perform an
interview utilizing BRC-67, "Diagnostic
Work Sheet" and re ...
Other materials:
Compression pressure
CHECKING COMPRESSION PRESSURE
Warm up the engine to full operating temperature.
Release the fuel pressure. Refer to EC-144, "Work Procedure".
Remove the ignition coil and spark plug from each cylinder. Refer
to EM-36, "Removal and Installation"
and ...
Filament
Inspection and Repair
INSPECTION
When measuring voltage, wrap tin foil around the top of the
negative
probe. Then press the foil against the wire with your finger.
Attach probe circuit tester (in Volt range) to middle portion of
each filament.
If a filament is b ...
How to use the [ ] button
For additional information, refer to the separate
Navigation System Owner’s Manual regarding
the “SiriusXM® Travel Link”, and “Traffic” features.
For additional information, refer to “Nissan-
ConnectSM with Mobile Apps” in this section
regarding “My Apps” key.
For ad ...
