Nissan Rogue (T33) 2021-Present Service Manual: B2e34-12 Tel Antenna
DTC Description
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | |
|---|---|---|---|
| B2E34-12 |
TEL antenna (Telephone antenna) |
Diagnosis condition | When ignition switch is ON |
| Signal (terminal) | TEL antenna signal | ||
| Threshold | Short to battery | ||
| Diagnosis delay time | 1 second or more | ||
POSSIBLE CAUSE
-
TEL antenna signal circuit is short to battery
-
TEL antenna
FAIL-SAFE
Telematics can not send and receive via network
DTC CONFIRMATION PROCEDURE
PERFORM DTC CONFIRMATION PROCEDURE
With CONSULT
-
Turn ignition switch ON.
-
Turn ignition switch OFF and wait at least 30 seconds.
-
Turn ignition switch ON and wait at least 30 seconds or more.
-
Select “Self Diagnostic Result” mode of “IVC” using CONSULT.
-
Check DTC.
Is DTC B2E34-12 detected?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
Diagnosis Procedure
CHECK TEL ANTENNA SIGNAL CIRCUIT
-
Turn ignition switch OFF.
-
Disconnect TCU harness connector.
-
Turn ignition switch ON.
-
Check the voltage between TCU harness connector (telematics antenna side) and ground.
(+) (−) Voltage
(Approx.)TCU Connector Terminal M174 47 Ground 0 V 48
Is the inspection result normal?
YES>>Replace TCU. Refer to Removal & Installation.
NO>>Replace telematics antenna. Refer to Removal & Installation.
Other materials:
System
Propilot Assist 2.1
System Description
SYSTEM DIAGRAM Component Description
ADAS control unit 2
ADAS Control Unit
GNSS antenna
ROOF ANTENNA AND ANTENNA FEEDER
HD map module
HD MAP MODULE
Front camera unit
Front Camera Unit
Steering assist switch
Steering As ...
U2b8c-88 Ethernet Circuit
DTC Description
DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detected condition
U2B8C-88
Ethernet circuit
Diagnosis condition
When ignition switch is ON.
Signal (terminal)
—
Threshold
Lost ethernet communication with driving video recorder control module
...
Mac Key Writing
Description
When replacing around view monitor control unit, it is necessary to
write MAC key to around view monitor control unit. Write MAC key to
around view monitor control unit according to "MAC Key writing"
procedure of "CONSULT Operation Manual". Refer to Work Procedure.CAUTION:
During ...
