Nissan Rogue (T33) 2021-Present Service Manual: B2731-49 Side Sensor [rr]
DTC Description
DTC DETECTION LOGIC
| DTC | CONSULT screen items (Trouble diagnosis content) | DTC detection condition | ||
|---|---|---|---|---|
| B2731-49 |
SIDE SENSOR [RR] (Side sensor [RR]) |
Diagnosis condition | When ignition switch is ON | |
| Signal (terminal) | — | |||
| Threshold | Sonar control unit is internal malfunctioning | |||
| Diagnosis delay time | 4 seconds or more | |||
POSSIBLE CAUSE
Sonar control unit
FAIL-SAFE
Stop the obstacle detection function
CONFIRMATION PROCEDURE
PERFORM DTC CONFIRMATION PROCEDURE
With CONSULT
-
Turn ignition switch ON.
-
Turn ignition switch OFF and wait at least 30 seconds.
-
Turn ignition switch ON and wait at least 30 seconds or more.
-
Select “Self Diagnostic Result” mode of “SONAR” using CONSULT.
-
Check the DTC.
Is DTC “B2731–49” detected?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
Diagnosis Procedure
PERFORM DTC CONFIRMATION PROCEDURE AGAIN
With CONSULT
-
Turn ignition switch ON.
-
Erase DTC.
-
Perform DTC confirmation procedure again. Refer to DTC Description.
Is DTC B2731-49 detected again?
YES>>Replace sonar control unit. Refer to Removal and Installation.
NO>>INSPECTION END
Other materials:
Front Wheel Hub and Knuckle
Exploded View
Steering knuckle
Splash guard
Hub bolt
Wheel hub and bearing assembly
Disc rotor
Wheel hub lock nut
: Comply with the installation procedure when tightening. Refer to Removal and Installation.
: N·m (kg-m, ft-lb)
: Always replace aft ...
Reporting safety defects
For USA
If you believe that your vehicle has a defect that could cause a crash or lead to injury or death, you should immediately inform the National Highway Traffic Safety Administration (NHTSA) in addition to notifying NISSAN. This applies whether you drive a Nissan Rogue or another NISSAN model.
...
Steering Switch Signal B Circuit
Component Function Check
CHECK COMBINATION METER INPUT SIGNAL
CONSULT
Ignition switch ON.
Select “Steering switch input” in “Data monitor” mode of “M&A”.
Check that the function operates normally according to the following conditions:
Condition Value
CONTRO ...
