Nissan Rogue (T33) 2021-Present Service Manual: B2731-47 Side Sensor [rr]
DTC Description
DTC DETECTION LOGIC
| DTC | CONSULT screen items (Trouble diagnosis content) | DTC detection condition | ||
|---|---|---|---|---|
| B2731-47 |
SIDE SENSOR [RR] (Side sensor [RR]) |
Diagnosis condition | When ignition switch is ON | |
| Signal (terminal) | — | |||
| Threshold | Sonar control unit sensor data lost | |||
| Diagnosis delay time | 4 seconds or more | |||
POSSIBLE CAUSE
The sonar control unit configuration is required.
FAIL-SAFE
Stop the obstacle detection function
CONFIRMATION PROCEDURE
PERFORM DTC CONFIRMATION PROCEDURE
With CONSULT
-
Turn ignition switch ON.
-
Turn ignition switch OFF and wait at least 30 seconds.
-
Turn ignition switch ON and wait at least 30 seconds or more.
-
Select “Self Diagnostic Result” mode of “SONAR” using CONSULT.
-
Check the DTC.
Is DTC “B2731–47” detected?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
Diagnosis Procedure
PERFORM CONFIGURATION OF SONAR CONTROL UNIT
Perform configuration of sonar control unit when DTC B2731–47 is detected.
>>
Perform configuration of sonar control unit. Refer to Description.
Other materials:
C106e-54 Steering Angle Sensor
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
C106E
54
Steering angle sensor
(Steering angle sensor)
Diagnosis condition
When ignition switch is ON.
When the power supply voltage is normal.
...
Tcm
Reference Value
CONSULT DATA MONITOR STANDARD VALUE
In CONSULT, electric shift timing or lock-up timing, i.e. operation
timing of each solenoid valve, is displayed. Therefore, if there is an
obvious difference between the shift timing estimated from a shift shock
(or engine speed variation ...
Chassis Can Communication 4 Circuit
Diagnosis Procedure
CHECK NETWORK DIAGNOSIS
Check the "Network diagnosis" results from CONSULT to see that the diagnostic CAN communication circuit have no malfunction.
Are the diagnostic CAN communication circuit normal?
YES>>
GO TO 2.
NO>>
Check and repair diagnostic CAN commu ...