Nissan Rogue (T33) 2021-Present Service Manual: B2730-68 Side Sensor [rl]

DTC Description

DTC DETECTION LOGIC

DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition
B2730-68

SIDE SENSOR [RL]

(Side sensor [RL])
Diagnosis condition When ignition switch is ON
Signal (terminal)
Threshold Magnetic noise detected
Diagnosis delay time 4 seconds or more

POSSIBLE CAUSE

  • Magnetic noise detected

  • Rear sonar sensor LH side

FAIL-SAFE

Stop the obstacle detection function

CONFIRMATION PROCEDURE

PERFORM DTC CONFIRMATION PROCEDURE

With CONSULT

  1. Turn ignition switch ON.

  2. Turn ignition switch OFF and wait at least 30 seconds.

  3. Turn ignition switch ON and wait at least 30 seconds or more.

  4. Select “Self Diagnostic Result” mode of “SONAR” using CONSULT.

  5. Check the DTC.

Is DTC “B2730–68” detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

Diagnosis Procedure

CHECK SONAR SENSOR

Check if there is any noise generating factor near sonar sensor.

Was there any factor?

YES>>

Remove a factor.

NO>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE AGAIN

With CONSULT

  1. Turn ignition switch ON.

  2. Erase DTC.

  3. Perform DTC confirmation procedure again. Refer to DTC Description.

Is DTC B2730-68 detected again?

YES>>

Replace the rear sonar sensor LH side. Refer to Removal and Installation.

NO>>

INSPECTION END

    B2730-65 Side Sensor [rl]
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition B2730-65 SIDE SENSOR [RL] (Side sensor [RL]) Diagnosis condition...
    B2730-81 Side Sensor [rl]
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition B27230-81 SIDE SENSOR [RL] Side sensor [RL] Diagnosis condition ...

    Other materials:

    C1203-86 Abs Signal
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detecting condition C1203-86 ABS SYSTEM (Antilock brake system) Diagnosis condition Ignition switch: ON Nissan Ariya Vehicle running Signal Wheel speed signals ...

    Chassis Can Communication 4 Circuit
    Diagnosis Procedure CHECK NETWORK DIAGNOSIS Check the "Network diagnosis" results from CONSULT to see that the diagnostic CAN communication circuit have no malfunction. Are the diagnostic CAN communication circuit normal? YES>> GO TO 2. NO>> Check and repair diagnostic CAN commu ...

    Heated steering wheel
    Example Push the heated steering wheel switch to warm the steering wheel after the engine starts. The indicator light A will illuminate once the system is active. If the steering wheel surface temperature is below 86–104ºF (30–40ºC), the system will automatically heat the wheel and cycle o ...