Nissan Rogue (T33) 2021-Present Service Manual: B2730-65 Side Sensor [rl]
DTC Description
DTC DETECTION LOGIC
| DTC | CONSULT screen items (Trouble diagnosis content) | DTC detection condition | ||
|---|---|---|---|---|
| B2730-65 |
SIDE SENSOR [RL] (Side sensor [RL]) |
Diagnosis condition | When ignition switch is ON | |
| Signal (terminal) | — | |||
| Threshold | Sonar sensor temperature is high | |||
| Diagnosis delay time | 4 seconds or more | |||
POSSIBLE CAUSE
-
Sonar sensor temperature is high
-
Rear sonar sensor LH side
FAIL-SAFE
Stop the obstacle detection function
CONFIRMATION PROCEDURE
PERFORM DTC CONFIRMATION PROCEDURE
With CONSULT
-
Turn ignition switch ON.
-
Turn ignition switch OFF and wait at least 30 seconds.
-
Turn ignition switch ON and wait at least 30 seconds or more.
-
Select “Self Diagnostic Result” mode of “SONAR” using CONSULT.
-
Check the DTC.
Is DTC “B2730–65” detected?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
Diagnosis Procedure
CHECK SONAR SENSOR
Check whether there is any factor which causes a temperature rise near sonar sensor.
Was there any factor?
YES>>Remove a factor.
NO>>GO TO 2.
PERFORM DTC CONFIRMATION PROCEDURE AGAIN
With CONSULT
-
Turn ignition switch ON.
-
Erase DTC.
-
Perform DTC confirmation procedure again. Refer to DTC Description.
Is DTC B2730-65 detected again?
YES>>Replace the rear sonar sensor LH side. Refer to Removal and Installation.
NO>>INSPECTION END
Other materials:
C1f41-84 Cvt
Without Propilot Assist 2.1
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
C1F41
84
TRANSMISSION CIRCUIT
(Transmission circuit)
Diagnosis condition
When engine is running
When AEB system is O ...
Cvt: Ge0f14a. Symptom Diagnosis
Cvt Control System
Symptom Table
The diagnosis item number indicates the order of check. Start checking in the order from 1.
Perform diagnoses of symptom table 1 before symptom table 2.
Symptom Table 1 Diagnostic item Reference Symptom
Shift Shock Slips/Will Not Engage Other
...
Power Supply and Ground Circuit
8ch Can Gateway
Diagnosis Procedure
CHECK FUSE
Check that the following fuse are not blown.
Signal name Fuse No.
Battery power supply
16
Ignition power supply
9
Is the fuse blown (open)?
YES>>
Replace the blown fuse after repairing the affected circuit if a fuse ...
