Nissan Rogue (T33) 2021-Present Service Manual: B2730-21 Side Sensor [rl]

DTC Description

DTC DETECTION LOGIC

DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition
B2730-21

SIDE SENSOR [RL]

(Side sensor [RL])
Diagnosis condition When ignition switch is ON
Signal (terminal) Rear sonar sensor signal LH side
Threshold The signal amplitude is small.
Diagnosis delay time 4 seconds or more

POSSIBLE CAUSE

  • Harness and connector between sonar control unit and rear sonar sensor LH side

  • Rear sonar sensor LH side

FAIL-SAFE

Stop the obstacle detection function

CONFIRMATION PROCEDURE

PERFORM DTC CONFIRMATION PROCEDURE

With CONSULT

  1. Turn ignition switch ON.

  2. Turn ignition switch OFF and wait at least 30 seconds.

  3. Turn ignition switch ON and wait at least 30 seconds or more.

  4. Select “Self Diagnostic Result” mode of “SONAR” using CONSULT.

  5. Check the DTC.

Is DTC “B2730–21” detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

Diagnosis Procedure

CHECK REAR SONAR SENSOR SIGNAL LH SIDE CIRCUIT (OPEN)

  1. Turn ignition switch OFF.

  2. Disconnect sonar control unit connector and rear sonar sensor LH side connector.

  3. Check continuity between sonar control unit harness connector and rear sonar sensor LH side connector

    Sonar control unit Rear sonar sensor LH side Continuity
    Connector Terminal Connector Terminal
    B49 49 B463 2 Existed

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair the harness or connector.

CHECK REAR SONAR SENSOR LH SIDE GROUND CIRCUIT

Check continuity between sonar control unit harness connector and rear sonar sensor LH side harness connector.

Sonar control unit Rear sonar sensor LH side Continuity
Connector Terminal Connector Terminal
B20 14 B463 3 Existed

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair the harness or connector.

CHECK REAR SONAR SENSOR SIGNAL LH SIDE

  1. Connect sonar control unit connector and rear sonar sensor LH side connector.

  2. Turn ignition switch ON.

  3. Check the signal between sonar control unit terminals as per the following condition.

    + Condition Voltage
    Sonar control unit
    Connector Terminal Connector Terminal
    B49 49 B20 14
    • Shift position is in R position.

    • When the sensor is detecting an obstacle

Is the inspection result normal?

YES>>

Replace the sonar control unit. Refer to Removal and Installation.

NO>>

Replace the rear sonar sensor LH side. Refer to Removal and Installation.

    B2730-17 Side Sensor [rl]
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition B2730-17 SIDE SENSOR [RL] (Side sensor [RL]) Diagnosis condition...
    B2730-29 Side Sensor [rl]
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition B2730-29 SIDE SENSOR [RL] (Side sensor [RL]) Diagnosis condition...

    Other materials:

    Corrosion protection
    Most common factors contributing to vehicle corrosion Moisture-retaining dirt and debris build-up inside body cavities or seams. Paint or coating damage caused by gravel, small stones or minor collisions. Environmental factors influencing corrosion rate Moisture Sand, dirt and water accumulat ...

    P1c90-49 Sub Starter & Generator
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition P1C90-49 Sub starter & generator (Sub starter & generator) Diagnosis condition Engine running at idle Signal (terminal) - Threshold Sub starte ...

    I-BSI driving situations
    Basic information Indicator on Indicator off Indicator flashing Illustration 1 — Approaching from behind Another vehicle approaching from behind Illustration 1: When another vehicle enters the monitored area from the rear in an adjacent lane, the side indicator light on the Nissan Rogue i ...