Nissan Rogue (T33) 2021-Present Service Manual: B272c-11 Corner Sensor [fr]

DTC Description

DTC DETECTION LOGIC

DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition
B272C-11

CORNER SENSOR [FR]

(Corner sensor [FR])
Diagnosis condition When ignition switch is ON
Signal (terminal) Front sonar sensor signal RH outer
Threshold Short to ground
Diagnosis delay time 4 seconds or more

POSSIBLE CAUSE

  • Harness and connector between sonar control unit and front sonar sensor RH outer

  • Front sonar sensor RH outer

FAIL-SAFE

Stop the obstacle detection function

CONFIRMATION PROCEDURE

PERFORM DTC CONFIRMATION PROCEDURE

With CONSULT

  1. Turn ignition switch ON.

  2. Turn ignition switch OFF and wait at least 30 seconds.

  3. Turn ignition switch ON and wait at least 30 seconds or more.

  4. Select “Self Diagnostic Result” mode of “SONAR” using CONSULT.

  5. Check the DTC.

Is DTC “B272C–11” detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

Diagnosis Procedure

CHECK FRONT SONAR SENSOR SIGNAL RH OUTER CIRCUIT (SHORT)

  1. Turn ignition switch OFF.

  2. Disconnect sonar control unit connector and front sonar sensor RH outer connector.

  3. Check continuity between sonar control unit harness connector and ground.

Sonar control unit Ground Continuity
Connector Terminal
B20 4 Not existed

Is the inspection result normal?

YES>>

Replace the Front sonar sensor RH outer. Refer to Removal and Installation.

NO>>

Repair the harness or connector.

    B272c-05 Corner Sensor [fr]
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition B272C-05 CORNER SENSOR [FR] (Corner sensor [FR]) Diagnosis condi...
    B272c-12 Corner Sensor [fr]
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition B272C-12 CORNER SENSOR [FR] (Corner sensor [FR]) Diagnosis condi...

    Other materials:

    Engine Stand Setting
    Setting NOTE: Explained here is how to disassemble with engine stand supporting transaxle surface. When using different type of engine stand, note with difference in steps and etc. Remove the engine and the transaxle assembly from the vehicle, and separate the transaxle from the engine. Ref ...

    Front Wheel Hub and Knuckle
    Exploded View Steering knuckle Splash guard Hub bolt Wheel hub and bearing assembly Disc rotor Wheel hub lock nut : Comply with the installation procedure when tightening. Refer to Removal and Installation. : N·m (kg-m, ft-lb) : Always replace aft ...

    B2e01-96 Tcu
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B2E01-96 Internal battery (Internal battery) Diagnosis condition When ignition switch is ON Signal (terminal) Internal battery Threshold Internal ba ...