Nissan Rogue (T33) 2021-Present Service Manual: B272b-92 Center Sensor [fr]

Nissan Rogue (T33) 2021-Present Service Manual / Driver Information & Multimedia :: Sonar System / Dtc/circuit Diagnosis :: Sonar (sonar Control Unit) / B272b-92 Center Sensor [fr]

DTC Description

DTC DETECTION LOGIC

DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition
B272B-92

CENTER SENSOR [FR]

(Center sensor [FR]) 		Diagnosis condition When ignition switch is ON
Signal (terminal) Front sonar sensor signal RH inner
Threshold An abnormal sensor signal is input from sonar sensor
Diagnosis delay time 4 seconds or more

POSSIBLE CAUSE

Front sonar sensor RH inner

FAIL-SAFE

Stop the obstacle detection function

CONFIRMATION PROCEDURE

PERFORM DTC CONFIRMATION PROCEDURE

With CONSULT

  1. Turn ignition switch ON.

  2. Turn ignition switch OFF and wait at least 30 seconds.

  3. Turn ignition switch ON and wait at least 30 seconds or more.

  4. Select “Self Diagnostic Result” mode of “SONAR” using CONSULT.

  5. Check the DTC.

Is DTC “B272B–92” detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

Diagnosis Procedure

PERFORM DTC CONFIRMATION PROCEDURE AGAIN

With CONSULT

  1. Turn ignition switch ON.

  2. Erase DTC.

  3. Perform DTC confirmation procedure again. Refer to DTC Description.

Is DTC B272B-92 detected again?

YES>>

Replace the front sonar sensor RH inner. Refer to Removal and Installation.

NO>>

INSPECTION END

    B272b-88 Center Sensor [fr]
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition B272B-88 CENTER SENSOR [FR] (Center sensor [FR]) Diagnosis condi...
    B272b-93 Center Sensor [fr]
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition B272B-93 CENTER SENSOR [FR] (Center sensor [FR]) Diagnosis condi...

    Other materials:

    Steering Switch Signal B Circuit
    Component Function Check CHECK COMBINATION METER INPUT SIGNAL CONSULT Ignition switch ON. Select “Steering switch input” in “Data monitor” mode of “M&A”. Check that the function operates normally according to the following conditions: Condition Value CONTRO ...

    Dtc/circuit Diagnosis. B100e-1a Knee Air Bag Module Rh
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition B100E-1A Knee air bag module RH (Knee air bag module right hand) Diagnosis condition When ignition switch is ON. Signal (terminal) Knee air bag module RH si ...

    Information Display (combination Meter)
    Door Open Warning DESIGN/PURPOSEInformation display warns the driver that each door is open or is not fully closed. Symbol Message – SYNCHRONIZATION WITH MASTER WARNING LAMPSynchronization is applied.Refer to Master Warning Lamp.SYSTEM DIAGRAMSIGNAL PATH BCM transmits door switch ...