Nissan Rogue (T33) 2021-Present Service Manual: B2729-93 Corner Sensor [fl]
DTC Description
DTC DETECTION LOGIC
| DTC | CONSULT screen items (Trouble diagnosis content) | DTC detection condition | ||
|---|---|---|---|---|
| B2729-93 |
CORNER SENSOR [FL] (Corner sensor [FL]) |
Diagnosis condition | When ignition switch is ON | |
| Signal (terminal) | Front sonar sensor signal LH outer | |||
| Threshold | An abnormal sensor signal is input from sonar sensor | |||
| Diagnosis delay time | 4 seconds or more | |||
POSSIBLE CAUSE
Front sonar sensor LH outer
FAIL-SAFE
Stop the obstacle detection function
CONFIRMATION PROCEDURE
PERFORM DTC CONFIRMATION PROCEDURE
With CONSULT
-
Turn ignition switch ON.
-
Turn ignition switch OFF and wait at least 30 seconds.
-
Turn ignition switch ON and wait at least 30 seconds or more.
-
Select “Self Diagnostic Result” mode of “SONAR” using CONSULT.
-
Check the DTC.
Is DTC “B2729–93” detected?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
Diagnosis Procedure
PERFORM DTC CONFIRMATION PROCEDURE AGAIN
With CONSULT
-
Turn ignition switch ON.
-
Erase DTC.
-
Perform DTC confirmation procedure again. Refer to DTC Description.
Is DTC B2729-93 detected again?
YES>>Replace the front sonar sensor LH outer. Refer to Removal and Installation.
NO>>INSPECTION END
Other materials:
U1cab-02 Intake Door Motor
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
U1CAB-02
Intake door motor
(Intake door motor)
Diagnosis condition
Ignition switch ON
Signal (Terminal)
LIN (door motor) signal
Threshold
A/C amp. i ...
Service Data and Specifications (sds)
General Specifications
BRAKE SYSTEMJAPAN PRODUCTION MODELS WITHOUT ProPILOT Assist 2.1Unit: mm (in) Front brake
Cylinder bore diameter
60.33 (2.3752)
Pad length × width × thickness
123.6 × 53.5 × 10.5 (4.87 × 2.106 × 0.413)
Rotor outer diameter × thickness
296 × 26.0 ( ...
Lane Branch Line Circuit
Diagnosis Procedure
CHECK CONNECTOR
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the front camera unitfor damage, bend and loose connection (unit side and connector side).
Is the inspection result no ...
