Nissan Rogue (T33) 2021-Present Service Manual: B2729-05 Corner Sensor [fl]

Nissan Rogue (T33) 2021-Present Service Manual / Driver Information & Multimedia :: Sonar System / Dtc/circuit Diagnosis :: Sonar (sonar Control Unit) / B2729-05 Corner Sensor [fl]

DTC Description

DTC DETECTION LOGIC

DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition
B2729-05

CORNER SENSOR [FL]

(Corner sensor [FL]) 		Diagnosis condition When ignition switch is ON
Signal (terminal) —
Threshold Configuration of sonar control unit is incomplete or wrong.
Diagnosis delay time 4 seconds or more

POSSIBLE CAUSE

  • Configuration incomplete

  • Configuration setting error

  • Front sonar sensor LH outer

FAIL-SAFE

Stop the obstacle detection function

CONFIRMATION PROCEDURE

PERFORM DTC CONFIRMATION PROCEDURE

With CONSULT

  1. Turn ignition switch ON.

  2. Turn ignition switch OFF and wait at least 30 seconds.

  3. Turn ignition switch ON and wait at least 30 seconds or more.

  4. Select “Self Diagnostic Result” mode of “SONAR” using CONSULT.

  5. Check the DTC.

Is DTC “B2729–05” detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

Diagnosis Procedure

PERFORM CONFIGURATION OF SONAR CONTROL UNIT

Perform configuration of sonar control unit when DTC B2729–05 is detected. Refer to Description.

>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE

With CONSULT

  1. Turn ignition switch ON.

  2. Delete the self diagnosis result.

  3. Perform DTC confirmation procedure again. Refer to DTC Description.

Is DTC “B2729–05” detected?

YES>>

Replace the front sonar sensor LH outer. Refer to Removal and Installation.

NO>>

INSPECTION END.

    B2724-55 Sonar Control Unit
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition B2724-55 SONAR CONTROL UNIT (Sonar control unit) Diagnosis condi...
    B2729-11 Corner Sensor [fl]
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition B2729-11 CORNER SENSOR [FL] (Corner sensor [FL]) Diagnosis condi...

    Other materials:

    Information Display (combination Meter)
    Door Open Warning DESIGN/PURPOSEInformation display warns the driver that each door is open or is not fully closed. Symbol Message – SYNCHRONIZATION WITH MASTER WARNING LAMPSynchronization is applied.Refer to Master Warning Lamp.SYSTEM DIAGRAMSIGNAL PATH BCM transmits door switch ...

    U216e-87 Can Comm Circuit
    DTC Description CAN (Controller Area Network) is a serial communication system for real time application. It is an on-Nissan Ariya vehicle multiplex communication system with high data communication speed and excellent error detectability. Many electronic control units are equipped onto Nis ...

    Electric Wastegate Control Actuator
    Component Inspection INSPECTION START Do you have CONSULT? Do you have CONSULT? YES>> GO TO 2. NO>> GO TO 3. CHECK ELECTRIC WASTEGATE CONTROL ACTUATOR With CONSULT Turn ignition switch ON and engine stopped. On the CONSULT screen, select “ENGINE”>>“ACTIVE ...