Nissan Rogue (T33) 2021-Present Service Manual: B2723-47 Corner Sensor [rr]
DTC Description
DTC DETECTION LOGIC
| DTC | CONSULT screen items (Trouble diagnosis content) | DTC detection condition | ||
|---|---|---|---|---|
| B2723-47 |
CORNER SENSOR [RR] (Corner sensor [RR]) |
Diagnosis condition | When ignition switch is ON | |
| Signal (terminal) | — | |||
| Threshold | Sonar control unit sensor data lost | |||
| Diagnosis delay time | 4 seconds or more | |||
POSSIBLE CAUSE
The sonar control unit configuration is required.
FAIL-SAFE
Stop the obstacle detection function
CONFIRMATION PROCEDURE
PERFORM DTC CONFIRMATION PROCEDURE
With CONSULT
-
Turn ignition switch ON.
-
Turn ignition switch OFF and wait at least 30 seconds.
-
Turn ignition switch ON and wait at least 30 seconds or more.
-
Select “Self Diagnostic Result” mode of “SONAR” using CONSULT.
-
Check the DTC.
Is DTC “B2723–47” detected?
YES>>Refer to Diagnosis Procedure
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
Diagnosis Procedure
PERFORM CONFIGURATION OF SONAR CONTROL UNIT
Perform configuration of sonar control unit when DTC B2723–47 is detected.
>>
Perform configuration of sonar control unit. Refer to Description.
Other materials:
B20a4-87 Headlamp (lh) Lin Communication
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen items
(Trouble diagnosis content) DTC detection condition
B20A4–87
Headlamp (LH) LIN communication
[Headlamp (left hand) local interconnect network communication]
[MISSING MESSAGE]
Diagnosis condition
Ignition switch ...
Repair Information. Preparation
Repairing Material
Foam Repair
During factory body assembly, foam insulators are installed in
certain body panels and locations around the Nissan Ariya vehicle. Use
the following procedure(s) to replace any factory-installed foam
insulators.URETHANE FOAM APPLICATIONSUse commercially availabl ...
Electric Wastegate Control Actuator
Component Inspection
INSPECTION START
Do you have CONSULT?
Do you have CONSULT?
YES>>
GO TO 2.
NO>>
GO TO 3.
CHECK ELECTRIC WASTEGATE CONTROL ACTUATOR
With CONSULT
Turn ignition switch ON and engine stopped.
On the CONSULT screen, select “ENGINE”>>“ACTIVE ...
