Nissan Rogue (T33) 2021-Present Service Manual: B2720-92 Corner Sensor [rl]
DTC Description
DTC DETECTION LOGIC
| DTC | CONSULT screen items (Trouble diagnosis content) | DTC detection condition | ||
|---|---|---|---|---|
| B2720-92 |
CORNER SENSOR [RL] (Corner sensor [rear left]) |
Diagnosis condition | When ignition switch is ON | |
| Signal (terminal) | Rear sonar sensor signal LH outer | |||
| Threshold | An abnormal sensor signal is input from sonar sensor | |||
| Diagnosis delay time | 4 seconds or more | |||
POSSIBLE CAUSE
Rear sonar sensor LH outer
FAIL-SAFE
Stop the obstacle detection function
CONFIRMATION PROCEDURE
PERFORM DTC CONFIRMATION PROCEDURE
With CONSULT
-
Turn ignition switch ON.
-
Turn ignition switch OFF and wait at least 30 seconds.
-
Turn ignition switch ON and wait at least 30 seconds or more.
-
Select “Self Diagnostic Result” mode of “SONAR” using CONSULT.
-
Check the DTC.
Is DTC “B2720–92” detected?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
Diagnosis Procedure
PERFORM DTC CONFIRMATION PROCEDURE AGAIN
With CONSULT
-
Turn ignition switch ON.
-
Erase DTC.
-
Perform DTC confirmation procedure again. Refer to DTC Description.
Is DTC B2720-92 detected again?
YES>>Replace the rear sonar sensor LH outer. Refer to Removal and Installation.
NO>>INSPECTION END
Other materials:
P14a5 Charge Air Cooler Cooling Electric Water Pump
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P14A5
Charge air cooler coolant pump
(Charge air cooler coolant pump control circuit high)
Diagnosis condition
Engine running at idle
Warm-up condition
...
Dtc/circuit Diagnosis. P161d-00 Immobilizer
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen items
(Trouble diagnosis content) DTC detecting condition
P161D-00
IMMOBILIZER
(Immobilizer)
Diagnosis condition
Ignition switch ON
Signal (terminal)
—
Threshold
When Intelligent Key unit detects an immob ...
Steering Switch Signal B Circuit
Component Function Check
CHECK COMBINATION METER INPUT SIGNAL
CONSULT
Ignition switch ON.
Select “Steering switch input” in “Data monitor” mode of “M&A”.
Check that the function operates normally according to the following conditions:
Condition Value
CONTRO ...
