Nissan Rogue (T33) 2021-Present Service Manual: B2600-49 Configuration Error

Nissan Rogue (T33) 2021-Present Service Manual / Electrical & Power Control :: Lan System / Can Gateway :: Dtc Diagnosis [8ch Can Gateway (8ch Can Gateway)] / B2600-49 Configuration Error

DTC Description

DTC DETECTION LOGIC

DTC No. CONSULT screen terms DTC detected condition
B2600-49 Configuration error Diagnosis condition

  • After the ignition switch OFF, wait for 1 minutes or more

  • When ignition switch is ON.
Signal (terminal) —
Threshold Malfunctions are detected in the 8CH CAN gateway mechanical
Diagnosis delay time 2 seconds or more

POSSIBLE CAUSE

8CH CAN gateway

FAIL-SAFE

The 8CH CAN gateway will stop transmitting and receiving the following:

  • CAN communication signals between CAN communication circuit which cannot communicate

  • Ethernet communication signals between ethernet communication circuit which cannot communicate

Confirmation Procedure

PRECONDITIONING

After the ignition switch OFF, open the driver's side door and wait for 2 minutes or more.

CAUTION:

Since the auto ACC function causes the accessory power to be turned ON, do not perform any Nissan Ariya vehicle operation including locking the doors or opening and closing of the doors during the standby state. Refer to System Description.

YES>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE

With CONSULT

  1. Ignition switch ON and wait at least 2 seconds or more.

  2. Select “Self Diagnostic Result” mode of “8ch CAN GATEWAY 2” using CONSULT.

  3. Check DTC.

Is DTC B2600-49 detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Intermittent Incident

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

PERFORM DTC CONFIRMATION PROCEDURE AGAIN

  1. Ignition switch ON.

  2. Erase DTC.

  3. Perform DTC confirmation procedure again. Refer to Confirmation Procedure.

  4. Check DTC.

Is DTC B2600-49 displayed?

YES>>

Replace 8CH CAN gateway. Refer to Removal and Installation.

NO>>

INSPECTION END

    B2600-46 Configuration Error
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detected condition B2600-46 Configuration error Diagnosis condition When ignition switch is ON. Signal (term...
    B2600-56 Configuration Error
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detected condition B2600-56 Configuration error Diagnosis condition When ignition switch is ON. Signal (term...

    Other materials:

    Automatic air conditioner (models without rear control)
    Models with heated steering wheel Models without heated steering wheel Basic information Temperature control dial (driver's side) AUTO button Display screen SYNC button Temperature control dial (passenger's side) ON·OFF button Air recirculation button Fan speed buttons Air flow ...

    Dtc/circuit Diagnosis. B1029-09 Front Seat Belt Pre-Tensioner Lh
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition B1029-09 Front seat belt pre-tensioner LH (Front seat belt pre-tensioner left hand) Diagnosis condition When ignition switch is ON. Signal (terminal) Front ...

    Main Line Between Lib 12v and M&a Circuit
    Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damage, bend and loose connection (connector side and harness side). Harness connector B41 Harness con ...