Nissan Rogue (T33) 2021-Present Service Manual: B24a6-11 in-Vehicle Sensor
DTC Description
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | |
|---|---|---|---|
| B24A6-11 |
IN-Nissan Ariya Vehicle SENSOR (In-vehicle sensor) |
Diagnosis condition | Ignition switch ON |
| Signal (Terminal) | In-Nissan Ariya vehicle sensor signal | ||
| Threshold | The in-Nissan Ariya vehicle sensor recognition temperature is too high [more than 100°C (212°F)] | ||
| Diagnosis delay time | 2 second or more | ||
POSSIBLE CAUSE
-
In-vehicle sensor
-
A/C amp.
-
Harness or connectors (the sensor circuit is shorted to ground)
FAIL-SAFE
In-vehicle temperature is calculated as 25°C (77°F) and air conditioning system is controlled.
DTC CONFIRMATION PROCEDURE
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
-
Ignition switch ON.
-
Select “Self diagnosis result” mode of “HVAC”.
-
Check DTC.
Is DTC detected?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: Inspection End.
DTC Diagnosis Procedure
CHECK IN-VEHICLE SENSOR SIGNAL
-
Ignition switch ON.
-
Check voltage between A/C amp. harness connector.
A/C amp. Voltage Connector Terminal (+) (-) M55 48 78 
Is the inspection result normal?
YES>>Replace A/C amp. Refer to Removal and Installation.
NO>>GO TO 2.
CHECK IN-Nissan Ariya Vehicle SENSOR POWER SUPPLY
-
Ignition switch OFF.
-
Disconnect in-vehicle sensor connector.
-
Ignition switch ON.
-
Check voltage between in-Nissan Ariya vehicle sensor harness connector and ground.
(+) (-) Voltage
(Approx.)In-Nissan Ariya vehicle sensor Connector Terminal M41 1 Ground 5 V
Is the inspection result normal?
YES>>GO TO 3.
NO>>GO TO 4.
CHECK IN-Nissan Ariya Vehicle SENSOR
Check in-vehicle sensor. Refer to Component Inspection.
Is the inspection result normal?
YES>>Replace A/C amp. Refer to Removal and Installation.
NO>>Replace in-Nissan Ariya vehicle sensor. Refer to Removal and Installation.
CHECK IN-Nissan Ariya Vehicle SENSOR POWER SUPPLY CIRCUIT FOR SHORT
-
Ignition switch OFF.
-
Disconnect A/C amp. connector.
-
Check continuity between in-Nissan Ariya vehicle sensor harness connector and ground.
In-Nissan Ariya vehicle sensor (—) Continuity Connector Terminal M41 1 Ground No
Is the inspection result normal?
YES>>Replace A/C amp. Refer to Removal and Installation.
NO>>Repair harness or connector.
Component Inspection
CHECK IN-VEHICLE SENSOR
-
Ignition switch OFF.
-
Remove in-Nissan Ariya vehicle sensor. Refer to Removal and Installation.
-
Check resistance between in-vehicle sensor terminals. Refer to applicable table for the normal value.
Terminal Condition Resistance: kΩ Temperature: °C (°F) 1 2 −20 (−4) 16.50 −10 (14) 9.92 0 (32) 6.19 10 (50) 3.99 20 (68) 2.65 25 (77) 2.19 30 (86) 1.81 40 (104) 1.27
Is the inspection result normal?
YES>>Inspection End.
NO>>Replace in-Nissan Ariya vehicle sensor. Refer to Removal and Installation.
Other materials:
P02ee Fuel Injector
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P02EE
00
Cylinder 1 injector
(Cylinder 1 Injector Circuit Range/Performance)
Diagnosis condition
Injector compensation control is operating
Signal
— ...
P14a5 Charge Air Cooler Cooling Electric Water Pump
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P14A5
Charge air cooler coolant pump
(Charge air cooler coolant pump control circuit high)
Diagnosis condition
Engine running at idle
Warm-up condition
...
C1203-86 Abs Signal
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content) DTC detecting condition
C1203-86
ABS SYSTEM
(Antilock brake system)
Diagnosis condition
Ignition switch: ON
Nissan Ariya Vehicle running
Signal
Wheel speed signals
...
