Nissan Rogue (T33) 2021-Present Service Manual: B24a0-49 A/c Auto Amp.

Nissan Rogue (T33) 2021-Present Service Manual / Ventilation, Heater & Air Conditioner :: Heater & Air Conditioning Control System / Automatic Air Conditioning :: Dtc/circuit Diagnosis / B24a0-49 A/c Auto Amp.

DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
B24A0-49

A/C AUTO AMP.

(Air conditioning automatic amplifier) 		Diagnosis condition Ignition switch ON
Signal (Terminal) —
Threshold A malfunction is detected in A/C amp. internal EEPROM memory functions.
Diagnosis delay time 2 second or more

POSSIBLE CAUSE

A/C amp.

FAIL-SAFE

—

DTC CONFIRMATION PROCEDURE

PERFORM SELF-DIAGNOSIS

CONSULT

  1. Ignition switch ON.

  2. Select “Self diagnosis result” mode of “HVAC”.

  3. Check DTC.

Is DTC detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

REPLACE A/C AMP.

Replace A/C amp. Refer to Removal and Installation.

>>

Inspection End.

    B2480-93 Rear Air Mix Door Motor
    DTC Description DTC DETECTION LOGICNOTE: If all of door motors DTC (B2480-93*, B24F5-93, B24F6-93, B24F7-93, B24F8-93) are detected, check “DOOR MOTOR”. Refer to Diagnosis P...
    B24a1-16 A/c Auto Amp. Power Supply
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B24A1-16 A/C AUTO AMP. POWER SUPPLY (Air conditioning automa...

    Other materials:

    Blind Spot Warning (BSW)
    Basic information WARNING Failure to follow the warnings and instructions for proper use of the Blind Spot Warning system could result in serious injury or death. The BSW system is not a substitute for safe driving practices. It cannot prevent collisions with nearby vehicles or objects. Always c ...

    Rear View Monitor. Removal and Installation. Rear View Camera
    Rear View Camera Removal and Installation REMOVALRemove the back door inner finisher. Refer to Removal and Installation. Remove the rear view camera mounting bolts , And then push the pawls in the direction of the arrow in the figure to remove the rear view camera. INSTALLATIONInstallation is ...

    Symptom Diagnosis. Squeak and Rattle Trouble Diagnoses
    Work Flow CUSTOMER INTERVIEWInterview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Worksheet during the interview to document the facts and conditions when the noise occurs and any customer comments. Refer to Diagnostic Worksheet ...