Nissan Rogue (T33) 2021-Present Service Manual: B221a-23 Steering Switch

Nissan Rogue (T33) 2021-Present Service Manual / Driver Information & Multimedia :: Meter, Warning Lamp & Indicator / Type B :: Dtc/circuit Diagnosis / B221a-23 Steering Switch

DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content) 		DTC detected condition
B221A-23

Steering SW input1

(Steering switch input1) 		Diagnosis condition When ignition switch is ON.
Signal (terminal) Steering switch signal
Threshold Switch stuck ON for 5 minutes
Diagnosis delay time 5 minutes or more

POSSIBLE CAUSE

  • Steering switch

  • Combination meter

  • Harness or connectors

FAIL-SAFE

—

DTC CONFIRMATION PROCEDURE

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Ignition switch ON and wait for 5 minutes or more.

  2. Select “Self diagnosis result” mode of “M&A”.

Is DTC B221A-23 detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: Inspection End.

Diagnosis Procedure

CHECK STEERING SWITCH SIGNAL A CIRCUIT

Check the steering switch signal A circuit. Refer to Component Function Check.

Is the inspection result normal?

YES>>

Replace combination meter. Refer to Removal and Installation

NO>>

Repair or replace malfunctioning parts.

    B2210-11 Ambient Air Temperature Sensor
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detected condition B2210-11 Outside temp sensor (Outside temp sensor) Diagnosis ...
    B221b-23 Steering Switch
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detected condition B221B-23 Steering SW input2 (Steering switch input2) Diagnosi...

    Other materials:

    Brake assist
    Brake assist When brake pedal force exceeds a certain threshold, Brake Assist activates to provide greater braking force than a conventional brake booster, even with relatively light pedal pressure. WARNING Brake Assist supports braking but does not replace careful driving. It is not a collision wa ...

    Steering Switch Signal B Circuit
    Component Function Check CHECK COMBINATION METER INPUT SIGNAL CONSULT Ignition switch ON. Select “Steering switch input” in “Data monitor” mode of “M&A”. Check that the function operates normally according to the following conditions: Condition Value CONTRO ...

    Tcm
    Reference Value CONSULT DATA MONITOR STANDARD VALUE In CONSULT, electric shift timing or lock-up timing, i.e. operation timing of each solenoid valve, is displayed. Therefore, if there is an obvious difference between the shift timing estimated from a shift shock (or engine speed variation ...