Nissan Rogue (T33) 2021-Present Service Manual: B2205-87 Vehicle Speed
DTC Description
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen terms (Trouble diagnosis content) | DTC detected condition | ||
|---|---|---|---|---|
| B2205-87 |
SPEED METER (Speed meter) |
Diagnosis condition | When ignition switch is ON. | |
| Signal (terminal) | Nissan Ariya Vehicle speed display signal | |||
| Threshold | Nissan Ariya Vehicle speed display signal is not input from ECM | |||
| Diagnosis delay time | 2 seconds or more | |||
POSSIBLE CAUSE
ECM
FAIL-SAFE
Reset to zero of the speedometer by suspending communication.
DTC CONFIRMATION PROCEDURE
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
-
Ignition switch ON and wait for 2 seconds or more.
-
Select “Self diagnosis result” mode of “M&A”.
-
Check DTC.
Is DTC B2205-87 detected?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: Inspection End.
Diagnosis Procedure
PERFORM SELF-DIAGNOSIS OF ECM
CONSULT
Select “Self diagnosis result” mode of “ECM.”
Is DTC detected?
YES>>Perform diagnosis procedure on the detected DTC. Refer to DTC Index.
NO>>GO TO 2.
PERFORM SELF-DIAGNOSIS OF ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)
CONSULT
Select “Self diagnosis result” mode of “ABS.”
Is DTC detected?
YES>>Perform diagnosis procedure on the detected DTC. Refer to DTC Index.
NO>>Inspection End.
Other materials:
P14a7 Charge Air Cooler Cooling Electric Water Pump
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P14A7
Charge air cooler cooling electric W/P
(Charge air cooler cooling electric water pump)
Diagnosis condition
Engine running at idle
Warm-up conditio ...
P00d2 Ho2s2 Heater
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P00D2
00
Heated O2 sensor heater B1 sensor 2
(HO2S heater control circuit range/performance bank 1 sensor 2)
Diagnosis condition
—
Signal (terminal)
...
Tcm
Reference Value
CONSULT DATA MONITOR STANDARD VALUE
In CONSULT, electric shift timing or lock-up timing, i.e. operation
timing of each solenoid valve, is displayed. Therefore, if there is an
obvious difference between the shift timing estimated from a shift shock
(or engine speed variation ...