Nissan Rogue (T33) 2021-Present Service Manual: B20c7-11 A/c Clutch

DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
B20C7–11

A/C clutch

(A/C clutch)
[CIRCUIT SHORT TO GROUND] Diagnosis condition When A/C switch is ON
Signal (Terminal) Magnetic clutch ON signal
Threshold Magnetic clutch ON signal circuit has a shorted to ground
Diagnosis delay time 1 second or more

POSSIBLE CAUSE

  • Harness or connectors (magnetic clutch ON signal circuit is shorted to ground)

  • IPDM E/R

FAIL-SAFE

Inhibit A/C compressor (magnetic clutch) operation

DTC CONFIRMATION PROCEDURE

PERFORM SELF DIAGNOSIS

CONSULT

  1. Start the engine.

  2. A/C switch ON.

  3. Select "Self diagnosis result" mode of "IPDM E/R".

  4. Check DTC.

Is DTC detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: Inspection End.

Diagnosis Procedure

CHECK MAGNETIC CLUTCH ON SIGNAL CIRCUIT FOR SHORT

  1. Ignition switch OFF.

  2. Disconnect IPDM E/R connector and A/C compressor connector.

  3. Check continuity between IPDM E/R harness connectors and the ground.

IPDM E/R Continuity
Connector Terminal
F35 65 Ground No

Is the inspection result normal?

YES>>

Replace IPDM E/R. Refer to Removal and Installation.

NO>>

Repair harness or connector.

    Manual Air Conditioning. Dtc/circuit Diagnosis
    B20c7-15 A/c Clutch
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B20C7–15 A/C clutch (A/C clutch) [CIRC SHORT TO BATT OR OP...

    Other materials:

    Dysfonctionnement du système
    En cas de dysfonctionnement du système d'intervention de changement de voie intelligent, celui-ci est automatiquement désactivé. Le témoin du système d'intervention de changement de voie intelligent (orange) s'allume, un signal sonore retentit et le message d'avertissement « Défaut du systèm ...

    Paddle Shifter
    Removal and Installation REMOVALFor servicing the Japan production paddle shifter, service the Japan production steering wheel. Refer to Removal and Installation.NOTE: The Japan production paddle shifter is serviced as an assembly with the Japan production ASCD steering switch (if so equip ...

    Engine oil
    Checking engine oil level Park the vehicle on a level area and apply the parking brake. Warm up the engine to operating temperature. Shut the engine off and wait at least 10 minutes. Remove the dipstick, wipe it clean, then fully reinsert it. Remove the dipstick again and check the oil le ...