Nissan Rogue (T33) 2021-Present Service Manual: B20a1-16 Ipdm E/r
DTC Description
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen items (Trouble diagnosis content) | DTC detection condition | ||
|---|---|---|---|---|
| B20A1-16 |
IPDM E/R (Intelligent power distribution module engine room) |
[CIRC VOLT BELOW THRESHOLD] | Diagnosis condition | When ignition switch is OFF |
| Signal (terminal) | Battery power supply voltage (terminal #2 and #81) | |||
| Threshold | Voltage do not match | |||
| Diagnosis delay time | 1 second or more | |||
POSSIBLE CAUSE
-
Fusible link
-
Harness or connectors (battery power supply circuit is open or shorted to ground)
-
IPDM E/R
FAIL-SAFE
—
DTC CONFIRMATION PROCEDURE
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
-
Ignition switch ON.
-
Ignition switch OFF and wait for 1 second or more.
-
Ignition switch ON.
-
Select “Self diagnosis result” mode of “IPDM E/R”.
Is DTC detected?
YES>>Refer to DTC Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: Inspection End.
DTC Diagnosis Procedure
CHECK FUSIBLE LINK
-
Ignition switch OFF.
-
Check that the following IPDM E/R fusible links are not blown (open):
Signal name Fusible link No. Capacity Battery power supply D 100A B 140A Z 30A
Is the fusible link blown (open)?
YES>>Replace the blown (open) fusible link after repairing the affected circuit if a fusible link is blown (open).
NO>>GO TO 2.
CHECK BATTERY POWER SUPPLY VOLTAGE
-
Disconnect IPDM E/R connector.
-
Check voltage between IPDM E/R harness connector and the ground.
+ - Voltage IPDM E/R Connector Terminal E118 2 Ground Battery voltage F41 81
Is the inspection result normal?
YES>>Replace IPDM E/R. Refer to Removal and Installation.
NO>>Repair the harness or connector.
Other materials:
Dtc/circuit Diagnosis. B0010-11 Assist A/b Module
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen items
(Trouble diagnosis content) DTC Detection Condition
B0010-11
ASSIST A/B MODULE
(Passenger Frontal Stage 1 Deployment Control)
Diagnosis condition
When ignition switch is ON.
Signal (terminal)
Passenger air ba ...
Symptom Diagnosis. Easy Fill Tire Alert Does Not Activate
Description
The easy fill tire alert does not function while inflating a tire
when the CVT shift selector position is in P-range with the ignition
switch ON or with the engine started.NOTE:
After starting to inflate the tire, it takes a few seconds for the easy fill tire alert to function. ...
Cvt: Ge0f14a. Symptom Diagnosis
Cvt Control System
Symptom Table
The diagnosis item number indicates the order of check. Start checking in the order from 1.
Perform diagnoses of symptom table 1 before symptom table 2.
Symptom Table 1 Diagnostic item Reference Symptom
Shift Shock Slips/Will Not Engage Other
...
