Nissan Rogue (T33) 2021-Present Service Manual: B120e-55 Ipdm E/r

Nissan Rogue (T33) 2021-Present Service Manual / Electrical & Power Control :: Power Control System / Ipdm E/r :: Dtc/circuit Diagnosis / B120e-55 Ipdm E/r

DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen items

(Trouble diagnosis content) 		DTC detection condition
B120E-55

IPDM E/R

(Intelligent power distribution module engine room) 		[NOT CONFIGURED] Diagnosis condition When ignition switch is ON
Signal (terminal) —
Threshold Configuration is not performed
Diagnosis delay time 1 second or more

POSSIBLE CAUSE

  • Configuration is not performed

  • IPDM E/R

FAIL-SAFE

—

DTC CONFIRMATION PROCEDURE

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Ignition switch ON.

  2. Select “Self diagnosis result” mode of “IPDM E/R”.

Is DTC detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

PERFORM CONFIGURATION (IPDM E/R)

  1. Perform configuration (IPDM E/R). Refer to Description.

  2. Perform DTC confirmation procedure. Refer to DTC Description.

Is DTC detected?

YES>>

Replace IPDM E/R. Refer to Removal and Installation.

NO>>

Inspection End.

    B120e-42 Ipdm E/r
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detection condition B120E-42 IPDM E/R (Intelligent power distribution module eng...
    B12a3-72 Fuel Pump Off Circuit
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detection condition B12A3-72 Fuel pump Off circuit (Fuel pump OFF circuit) [ACTU...

    Other materials:

    Fuel Pump Control Module
    Component Inspection CHECK FUEL PUMP CONTROL MODULE (FPCM) Check the voltage between FPCM terminals under the following conditions. FPCM Condition Voltage (Approx.) Connector + − Terminal B97 6 5 For 1 second after turning ignition switch ON 9.9 V More than ...

    Ignition Signal
    Component Function Check INSPECTION START Turn ignition switch OFF, and restart engine. Does the engine start? YES-1>> With CONSULT: GO TO 2. YES-2>> Without CONSULT: GO TO 3. NO>> Refer to Diagnosis Procedure. CHECK IGNITION SIGNAL FUNCTION-1 With CONSULT Perfor ...

    Symptom Diagnosis. Engine Can Not Start
    Description Engine does not start when push-button ignition switch is pressed.SYMPTOM TABLE (BOTH INTELLIGENT KEYS HAVE THE SAME SYMPTOMS) Door lock operation (remote keyless entry) Door lock operation (request switch of front/rear/back door) or trunk/back door open operation (opener switch of ...