Nissan Rogue (T33) 2021-Present Service Manual: Additional Service When Replacing Side Radar

Nissan Rogue (T33) 2021-Present Service Manual / Cruise Control & Driver Assistance :: Driver Assistance System / Driver Assistance System :: Basic Inspection / Additional Service When Replacing Side Radar

Work Procedure

Always perform the side radar configuration after replacing the side radar.

SIDE RADAR CONFIGURATION

Perform saving vehicle internal information according to "Replace ECU" in CONSULT Operation Manual.

>>

GO TO 2.

SIDE RADAR ALIGNMENT

Perform the side radar alignment with CONSULT. Refer to Work Procedure.

YES>>

GO TO 3.

PERFORM SELF-DIAGNOSIS

Perform the self-diagnosis of side radar with CONSULT. Check if any DTC is detected.

Is any DTC detected?

YES>>

Perform the trouble diagnosis for the detected DTC.

  • Side radar (Front left): Refer to DTC Index.

  • Side radar (Front right): Refer to DTC Index.

  • Side radar (Rear left): Refer to DTC Index.

  • Side radar (Rear right): Refer to DTC Index.

NO>>

INSPECTION END

    Camera Aiming Adjustment
    Work Procedure Always adjust the camera aiming after removing and installing or replacing the front camera unit. Always adjust the camera aiming after removing and installing or...
    Side Radar Alignment
    Work Procedure Always perform the side radar alignment after performing the following work. After removing and installing or replacing the side radar. After removing and install...

    Other materials:

    P044a Egr Volume Contro Valve Position Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P044A 00 EGR SENSOR C (EGR sensor C circuit low) Diagnosis condition Ignition switch ON Signal (terminal) EGR volume control valve signal Threshol ...

    P0486 Egr Differential Pressure Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0486 00 EGR SENSOR B (EGR sensor B circuit) Diagnosis condition — Signal (terminal) — Threshold ECM detects that a voltage signal from EGR ...

    Lib 12v Branch Line Circuit
    Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side). 12V sub battery (lithium ion battery) ...