Nissan Rogue (T33) 2021-Present Service Manual: Abs Warning Lamp
Component Function Check
CHECK ABS WARNING LAMP FUNCTION
Check that ABS warning lamp in combination meter turns ON for approximately 1 second after ignition switch is ON.
CAUTION:
Never start engine.
Is the inspection result normal?
YES>>Inspection End
NO>>Refer to Diagnosis Procedure.
Diagnosis Procedure
CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) POWER SUPPLY AND GROUND CIRCUIT
Perform the trouble diagnosis for ABS actuator and electric unit (control unit) power supply and ground circuit. Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Repair / replace harness, connector, terminal, fuse, or fusible link.
PERFORM SELF-DIAGNOSIS
CONSULT
Perform self-diagnosis for “ABS”.
Is any DTC detected?
YES>>Check the DTC. Refer to DTC Index.
NO>>Check combination meter.
-
Type A: Refer to On Board Diagnosis Function.
-
Type B: Refer to On Board Diagnosis Function.
Other materials:
Towing load/specification
WARNING
The towing capacities in this manual are general guidelines. Actual safe towing capacity of your Nissan Rogue depends on factory or dealer-installed equipment, passenger load, and cargo weight. You must weigh both the vehicle and trailer as described to determine true towing capacity. Never ...
Symptom Diagnosis. Squeak and Rattle Trouble Diagnoses
Work Flow
CUSTOMER INTERVIEWInterview
the customer if possible, to determine the conditions that exist when
the noise occurs. Use the Diagnostic Worksheet during the interview to
document the facts and conditions when the noise occurs and any of
customer's comments; Refer to Diagnostic Work ...
Dtc/circuit Diagnosis. B1029-09 Front Seat Belt Pre-Tensioner Lh
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen items
(Trouble diagnosis content) DTC Detection Condition
B1029-09
Front seat belt pre-tensioner LH
(Front seat belt pre-tensioner left hand)
Diagnosis condition
When ignition switch is ON.
Signal (terminal)
Front ...