Nissan Rogue Service Manual: Periodic maintenance
FRONT WHEEL HUB AND KNUCKLE
Inspection
- Move the wheel hub and bearing in an axial direction by hand to verify that looseness of wheel hub and bearing exists. If any looseness exists, replace the wheel hub and bearing.
Axial end play : Refer to FAX-32, "Wheel Bearing".
- Rotate wheel hub and bearing to verify if unusual noises or other irregular conditions exist. If any irregular conditions exist, replace the wheel hub and bearing.
FRONT DRIVE SHAFT
Inspection
Check the following items and replace parts as necessary:
- Check drive shaft mounting point and joint for looseness and other damage.
- Check boot for cracks and other damage.
CAUTION: Replace entire drive shaft when noise or vibration occurs from drive shaft.
Symptom diagnosis
NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOO
NVH Troubleshooting Chart
Use chart below to find the cause of the symptom. If necessary, repair or
replace these parts.
×: Applicable ...
Removal and installation
FRONT WHEEL HUB
Exploded View
Disc brake rotor
Nut retainer
Cotter pin
Wheel stud
Steering knuckle
Splash guard
Wheel hub and bearing
Wheel hub lock n ...
Other materials:
Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT
BELT
PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”,
used along
with a front seat belt, helps to reduce the risk or severity of injury to the
...
Fuel gauge
Fuel gauge
The gauge indicates the approximate fuel level
in the tank.
The gauge may move slightly during braking,
turning, acceleration, or going up or down hills.
The gauge needle returns to 0 (Empty) after the
ignition switch is placed in the OFF position.
The low fuel warning ligh ...
P0122, P0123 TP sensor
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
P0122
TP SEN 2/CIRC-B1
(Throttle/pedal position sensor/switch ″A″
circuit low)
An excessively low voltage from the TP sensor 2 is se ...
