Nissan Rogue manuals

Nissan Rogue Service Manual: P062F EEPROM

Description

TCM compares the calculated value stored in the flash ROM with the value stored in TCM. If the calculated value does not agree with the stored value, TCM judges this as a malfunction.

DTC Description

TCM compares the calculated value stored in the flash ROM with the value stored in TCM. If the calculated value does not agree with the stored value, TCM judges this as a malfunction.

DTC DETECTION LOGIC

DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition
P062F EEPROM (Internal Control Module EEPROM Error) Flash ROM error is detected when turning ON the ignition switch.

POSSIBLE CAUSE

FAIL-SAFE

Not changed from normal driving

DTC CONFIRMATION PROCEDURE

1.PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

>> GO TO 2.

2.CHECK DTC DETECTION

  1.  Start the engine.
  2.  Check the DTC.

Is “P062F” detected? YES >> Go to TM-106, "Diagnosis Procedure".

NO-1 >> To check malfunction symptom before repair: Refer to GI-41, "Intermittent Incident".

NO-2 >> Confirmation after repair: INSPECTION END

Diagnosis Procedure

1.REPLACE TCM

Replace the TCM. Refer to TM-202, "Removal and Installation".

>> WORK END

U1117 lost communication (ABS)
DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition U1117 LOST COMM (ABS) (Lost Communication With ABS) ...

P0705 transmission range sensor A
DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0705 T/M RANGE SENSOR A [Transmission Range Sensor A ...

Other materials:

P0506 ISC system
Description The ECM controls the engine idle speed to a specified level through the fine adjustment of the air, which is let into the intake manifold, by operating the electric throttle control actuator. The operating of the throttle valve is varied to allow for optimum control of the engine ...

Meter control switch signal circuit
Diagnosis Procedure Regarding Wiring Diagram information, refer to MWI-32, "Wiring Diagram". 1.CHECK METER CONTROL SWITCH SIGNAL  Turn ignition switch ON.  Check voltage between the following terminals of the meter control switch harness connector M3. Is the ins ...

Symptom diagnosis
INTERIOR LIGHTING SYSTEM SYMPTOMS Symptom Table CAUTION: Perform the self-diagnosis with CONSULT before the symptom diagnosis. Perform the trouble diagnosis if any DTC is detected. Symptom Possible cause Inspection item All the following lamps do not turn ON. ...

© 2014-2025 Copyright www.nirogue.com