Nissan Rogue (T33) 2021-Present Service Manual: U2852-87 Ethernet Circuit

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
 
U2852 87

Ethernet circuit

(Ethernet circuit)
Diagnosis condition When engine is running
Signal (terminal) Ethernet
Threshold If ADAS control unit 2 is not receiving ethernet communication signal from front camera unit
Diagnosis delay time 5 seconds or more

POSSIBLE CAUSE

  • Ethernet harness

  • ADAS control unit 2

  • Front camera unit

FAIL-SAFE

The following systems are canceled.

  • Vehicle-to-vehicle distance control mode

  • Conventional (fixed speed) cruise control mode

  • Steering wheel assistance function

  • AEB

  • RAB

  • I-FCW

  • LDW

  • I-LI

  • BSW

  • I-BSI

  • RCTA

  • TSR

  • I-DA

CONFIRMATION PROCEDURE

PERFORM DTC CONFIRMATION PROCEDURE

  1. Start the engine and wait at least 5 seconds.

  2. Perform “All DTC Reading” with CONSULT.

  3. Check if the DTC “U2852-87” is detected as the current malfunction in “Self Diagnostic Result” of “ICC/ADAS 2”.

Is DTC “U2852-87” detected as the current malfunction?

YES>>

Refer to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

CHECK CONNECTOR

  1. Ignition switch OFF.

  2. Check the ethernet harness connectors and terminals of ADAS control unit 2 and front camera unit for damage or looseness.

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair or replace the malfunction part, securely lock the harness connector.

PERFORM ALL DTC READING

  1. Ignition switch ON.

  2. Perform “All DTC Reading” with CONSULT.

  3. Check if any DTCs of ethernet (DTC “C250C-88” and/or “U276B-88”) are detected in “Self Diagnostic Result” of “LANE CAMERA”

Are any DTCs of ethernet detected?

YES>>

Replace the ADAS control unit 2 (Refer to Removal and Installation), and GO TO 3.

NO>>

Replace the front camera unit. Refer to Removal and Installation.

PERFORM DTC CONFIRMATION PROCEDURE-1

  1. Erases all self-diagnosis results with CONSULT.

  2. Perform DTC confirmation procedure again. Refer to DTC Description.

Is DTC “U2852-87” detected as the current malfunction?

YES>>

Replace the front camera unit (Refer to Removal and Installation), and GO TO 4.

NO>>

INSPECTION END

PERFORM DTC CONFIRMATION PROCEDURE-2

  1. Erases all self-diagnosis results with CONSULT.

  2. Perform DTC confirmation procedure again. Refer to DTC Description.

Is DTC “U2852-87” detected as the current malfunction?

YES>>

Replace the ethernet harness between ADAS control unit 2 and front camera unit.

NO>>

INSPECTION END

    U2752-88 Ethernet Circuit
    Without Propilot Assist 2.1 DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition U2752 88 Ethernet circuit (Ethernet ...
    U2852-88 Ethernet Circuit
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition U2852 88 Ethernet circuit (Ethernet circuit) Diagnosis condition...

    Other materials:

    Removal and Installation. Tire Pressure Sensor
    Exploded View Screw Tire pressure sensor Valve Valve core Valve cap : Comply with the assembly procedure when tightening. Refer to Removal and Installation. : N·m (kg-m, in-lb) : Always replace after every disassembly. Removal & Install ...

    Dtc/circuit Diagnosis. B0038-11 Rear Side A/b Module Rh
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition B0038-11 REAR SIDE A/B MODULE RH (Second Row Right Side Airbag Deployment Control) Diagnosis condition When ignition switch is ON. Signal (terminal) Rear si ...

    Drive Pinion
    Kr15ddt Exploded View Drive pinion lock nut Companion flange Dust shield Drive pinion oil seal Pinion bearing assembly O-ring Drive pinion adjusting shim Drive pinion O-ring Transfer case oil seal Dowel pin Plug Gasket T ...