Nissan Rogue (T33) 2021-Present Service Manual: U215b Can Comm Circuit

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
U215B 83

CAN comm err (IPDM E/R)

[CAN comm err (IPDM E/R)]
Diagnosis condition Ignition switch ON
Signal (terminal) CAN communication signal
87 Threshold ECM is not receiving CAN communication signal other than OBD (emission related diagnosis).
Diagnosis delay time 30 seconds or more

POSSIBLE CAUSE

  • Harness or connectors (CAN communication line is open or shorted)

  • IPDM E/R

FAIL-SAFE

Not applicable

DTC CONFIRMATION PROCEDURE

CHECK DTC PRIORITY

If DTC U215B is displayed with DTC P0607, first perform the confirmation procedure (trouble diagnosis) for DTC P0607.

Is DTC P0607 detected?

YES>>

Proceed to DTC Description.

NO>>

GO TO 2.

PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

  1. Ignition switch OFF and wait at least 10 seconds.

  2. Ignition switch ON.

  3. Ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is 11 V or more at idle.

>>

GO TO 3.

PERFORM DTC CONFIRMATION PROCEDURE

  1. Ignition switch ON and wait at least 3 seconds.

  2. Check 1st trip DTC.

Is DTC U215B detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

Diagnosis Procedure

CHECK DTC PRIORITY

If DTC U215B is displayed with DTC P0607, first perform the confirmation procedure (trouble diagnosis) for DTC P0607.

Is DTC P0607 detected?

YES>>

Proceed to DTC Description.

NO>>

Perform the trouble diagnosis for CAN communication system. Refer to Trouble Diagnosis Flow Chart.

    U2153 Can Comm Circuit
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition U2153 87 CAN comm err (HVAC) ch1 [CAN comm err (HVAC) ch1] Diagn...
    U2175 Can Comm Circuit
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition U2175 57 CAN comm err (AVM) [CAN comm err (AVM)] Diagnosis condi...

    Other materials:

    Filtre à air
    Pour retirer le filtre à air, libérez les goupilles d’arrêt 1 puis soulevez l’ensemble dans le sens indiqué 2. L’élément filtrant en papier visqueux (si le véhicule en est équipé) ne doit jamais être nettoyé ni réutilisé. L’élément filtrant en papier sec peut, quant à ...

    Rear Automatic Braking. Ecu Diagnosis Information. Adas Control Unit 2
    Adas Control Unit 2 List of ECU Reference ECU Reference ADAS control unit 2 Reference Value Fail-safe (ADAS Control Unit 2) DTC Inspection Priority Chart DTC Index ...

    Basic Inspection. Instructions for Releasing Parking Brake Where Parking Brake Switch Cannot Be Used
    Description Disconnecting the 12V battery negative terminal with the parking brake on, prevents the parking brake from releasing. Releasing is performed mechanically. Refer to Work Procedure. Work Procedure DISCONNECT PARKING BRAKE ACTUATOR HARNESS CONNECTOR Disconnecting the 12V battery ...