Nissan Rogue (T33) 2021-Present Service Manual: U214e-87 Can Comm Circuit

Nissan Rogue (T33) 2021-Present Service Manual / Transmission & Driveline :: Driveline / Transfer: Ty92a :: Dtc/circuit Diagnosis / U214e-87 Can Comm Circuit

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content) 		DTC detecting condition
U214E-87

CAN comm err (combination meter)

[Controller area network communication error (combination meter)] 		Diagnosis condition Ignition switch: ON
Signal CAN communication signals
Threshold Not receiving CAN signal from combination meter.
Diagnosis delay time 2 seconds or more

POSSIBLE CAUSE

  • CAN communication system

  • Combination meter

FAIL-SAFE

No impact to vehicle behavior (continue normal AWD control).

DTC CONFIRMATION PROCEDURE

PRECONDITIONING

If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always place ignition switch OFF and wait at least 10 seconds before conducting the next test.

>>

GO TO 2.

DTC REPRODUCTION PROCEDURE

CONSULT

  1. Ignition switch ON.

  2. Drive at 10 km/h (6 MPH) or more for approximately 5 minutes in urban areas.

  3. Stop the Nissan Ariya vehicle.

  4. Perform "Self diagnosis result" mode of “AWD/4WD”.

Is DTC “U214E-87” detected?

YES>>

Proceed to diagnosis procedure. Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

PERFORM SELF DIAGNOSIS OF COMBINATION METER

CONSULT

Perform "Self diagnosis result" mode of “M&A”.

Is any DTC detected?

YES>>

Check the DTC. Refer to DTC Index (type A meter) or DTC Index (type B meter).

NO>>

GO TO 2.

CHECK TERMINALS AND HARNESS CONNECTORS

Check AWD control unit pin terminals for damage or loose connection with harness connector.

Is inspection result normal?

YES>>

After placing the ignition switch OFF, perform DTC confirmation procedure again. If DTC “U214E-87” is detected, replace actuator assembly due to the malfunction of the AWD control unit. Refer to Disassembly and Assembly.

NO>>

Repair or replace error-detected parts.

    U2141-87 Can Comm Circuit
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detecting condition U2141-87 CAN comm err (TCM) [Controller area network communicati...
    U214f-87 Can Comm Circuit
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detecting condition U214F-87 CAN comm err (BCM) [Controller area network communicati...

    Other materials:

    Dtc/circuit Diagnosis. B2428-46 Automatic Back Door Control Unit
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition B2428-46 Automatic back door control unit (Automatic back door control unit) Diagnosis condition All times Signal (terminal) — Threshold Automatic ...

    System
    Propilot Assist 2.1 System Description SYSTEM DIAGRAM Component Description ADAS control unit 2 ADAS Control Unit GNSS antenna ROOF ANTENNA AND ANTENNA FEEDER HD map module HD MAP MODULE Front camera unit Front Camera Unit Steering assist switch Steering As ...

    P1c90-49 Sub Starter & Generator
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition P1C90-49 Sub starter & generator (Sub starter & generator) Diagnosis condition Engine running at idle Signal (terminal) - Threshold Sub starte ...