Nissan Rogue (T33) 2021-Present Service Manual: U2140-87 Can Comm Circuit
DTC Description
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | |
|---|---|---|---|
| U2140-87 |
CAN comm err (ECM) [Control Area Network communication error (ECM)] |
Diagnosis condition | When ignition switch is ON |
| Signal (terminal) | CAN communication signal | ||
| Threshold | Sonar control unit cannot communicate CAN communication signal | ||
| Diagnosis delay time | 2 seconds or more | ||
POSSIBLE CAUSE
CAN communication system
FAIL-SAFE
—
CONFIRMATION PROCEDURE
PERFORM DTC CONFIRMATION PROCEDURE
With CONSULT
-
Turn ignition switch ON.
-
Turn ignition switch OFF and wait for 30 seconds.
-
Turn ignition switch ON and wait at least 2 seconds or more.
-
Select “Self Diagnostic Result” mode of “SONAR” using CONSULT.
-
Check DTC.
Is DTC U2140-87 detected?
YES>>Proceed to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
Diagnosis Procedure
PERFORM DTC CONFIRMATION PROCEDURE AGAIN
With CONSULT
-
Turn ignition switch ON.
-
Erase DTC.
-
Perform DTC confirmation procedure again. Refer to DTC Description.
Is DTC U2140-87 detected again?
YES>>Perform the trouble diagnosis for CAN communication system. Refer to Trouble Diagnosis Flow Chart.
NO>>INSPECTION END
Other materials:
Charge Air Cooler
Exploded View
Charge air cooler
Charge air cooler Bracket 1
Turbocharger boost sensor (with intake air temperature sensor 2)
O-ring
Electronic throttle control actuator gasket
Charge air cooler Bracket 2
Air inlet hose
To r ...
Dtc/circuit Diagnosis. B1002-13 Lap Pre-Tensioner Rh
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen items
(Trouble diagnosis content) DTC Detection Condition
B1002-13
Lap pre-tensioner RH
(Lap pre-tensioner right hand)
Diagnosis condition
When ignition switch is ON.
Signal (terminal)
Lap pre-tensioner RH signal
...
Main Line Between Lib 12v and M&a Circuit
Diagnosis Procedure
CHECK CONNECTOR
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Check the following terminals and connectors for damage, bend and loose connection (connector side and harness side).
Harness connector B41
Harness con ...
