Nissan Rogue (T33) 2021-Present Service Manual: U1325-54 Configuration Incompletion

Nissan Rogue (T33) 2021-Present Service Manual / Electrical & Power Control :: Lan System / Can Gateway :: Dtc Diagnosis [8ch Can Gateway (8ch Can Gateway)] / U1325-54 Configuration Incompletion

DTC Description

DTC DETECTION LOGIC

DTC No. CONSULT screen terms DTC detected condition
U1325-54 Configuration incompletion Diagnosis condition When ignition switch is ON.
Signal (terminal) —
Threshold Programming is incomplete
Diagnosis delay time 2 seconds or more

POSSIBLE CAUSE

  • Programming is incomplete

  • 8CH CAN gateway

FAIL-SAFE

The 8CH CAN gateway will stop transmitting and receiving the following:

  • CAN communication signals between each CAN communication circuit

  • Ethernet communication signals between each ethernet communication circuit

Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE

With CONSULT

  1. Ignition switch ON and wait at least 2 seconds or more.

  2. Select “Self Diagnostic Result” mode of “8ch CAN GATEWAY 2” using CONSULT.

  3. Check DTC.

Is DTC U1325–54 detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Intermittent Incident

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

PERFORM PROGRAMMING OF 8CH CAN GATEWAY

Perform 8CH CAN gateway programming. Refer to Work Procedure.

>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE AGAIN

  1. Ignition switch ON.

  2. Perform DTC confirmation procedure again. Refer to Confirmation Procedure.

  3. Check DTC.

Is DTC U1325-54 displayed?

YES>>

Replace 8CH CAN gateway. Refer to Removal and Installation.

NO>>

INSPECTION END

    B261f-97 Communication Error
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detected condition B261F-97 Communication error Diagnosis condition After the ignition switch OFF, wait for ...
    U2340-87 Can Comm Circuit
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detected condition U2340-87 CAN communication error (ECM) Diagnosis condition When ignition switch is ON. Si...

    Other materials:

    C1f80-55 Steering Wheel Touch Sensor
    Without Propilot Assist 2.1 DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition C1F80 55 Steering wheel touch sensor (Steering wheel touch sensor) Diagnosis condition When engine is running Signal (terminal) ...

    Mac Key Writing
    Description When replacing around view monitor control unit, it is necessary to write MAC key to around view monitor control unit. Write MAC key to around view monitor control unit according to "MAC Key writing" procedure of "CONSULT Operation Manual". Refer to Work Procedure.CAUTION: During ...

    Lane Branch Line Circuit
    Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the front camera unitfor damage, bend and loose connection (unit side and connector side). Is the inspection result no ...