Nissan Rogue (T33) 2021-Present Service Manual: U007a-00 Can Comm Circuit
DTC Description
DTC DETECTION LOGIC
| DTC No. | CONSULT screen terms | DTC detection condition | ||
|---|---|---|---|---|
| U007A | 00 | Control module communication Bus H Off | Diagnosis condition | When ignition switch is ON. |
| Signal (terminal) | CAN communication signal | |||
| Threshold | Not transmitting. | |||
| Diagnosis delay time | 2 seconds or more | |||
POSSIBLE CAUSE
CAN communication system
FAIL-SAFE
The following functions are suspended.*
-
Intelligent trace control function
-
Active ride control function
-
Automatic brake hold function
-
Drive mode selector function
*: Depends on the DTC detection status
DTC CONFIRMATION PROCEDURE
PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always ignition switch OFF and wait at least 10 seconds before conducting the next test.
>>
GO TO 2.
CHECK DTC DETECTION
With CONSULT
-
Ignition switch OFF to ON.
CAUTION:
Be sure to wait of 10 seconds after ignition switch OFF or ON.
-
Perform self-diagnosis for “CHASSIS CONTROL”.
Is DTC “U007A-00” detected?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
Diagnosis Procedure
Proceed to Trouble Diagnosis Flow Chart.
Other materials:
Dtc/circuit Diagnosis. B0028-09 Side A/b Module Rh
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen items
(Trouble diagnosis content) DTC Detection Condition
B0028-09
SIDE A/B MODULE RH
(Right Side Airbag Deployment Control)
Diagnosis condition
When ignition switch is ON.
Signal (terminal)
Front side air bag modu ...
C107c-53 Not Configuration
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
C107C
53
Not configuration
(Not configuration)
Diagnosis condition
When ignition switch is ON.
When the power supply voltage is normal.
Signa ...
U2e52-87 Can Comm Circuit
DTC Description
DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detection condition
U2E52
87
CAN communication error (ADAS control unit)
Diagnosis condition
When ignition switch is ON.
Signal (terminal)
CAN communication signal
Threshold
Not receiving from ADAS c ...
