Nissan Rogue (T33) 2021-Present Service Manual: Transfer Oil Temperature Sensor
Component Inspection
CHECK TRANSFER OIL TEMPERATURE SENSOR
-
Ignition switch OFF.
-
Remove transfer oil temperature sensor. Refer to Removal and Installation.
-
Check the resistance between transfer oil temperature sensor connector terminals.
-
Make measuring condition using burning hot water.
CAUTION:
-
Prevent a burn from the burning hot water.
-
Be sure to dry the sensor after checking.
Transfer oil temperature sensor Condition Resistance
(Approx.)Terminal 1 2 100°C (212°F) 5.563 – 6.997 kΩ -
Is the inspection result normal?
YES>>Inspection End.
NO>>Replace transfer oil temperature sensor. Refer to Removal and Installation.
Other materials:
System Description. System
Eps System
System Description
SYSTEM DIAGRAM Parts name Function
Power steering control module
Refer to STEERING GEAR ASSEMBLY.
EPS motor
Refer to STEERING GEAR ASSEMBLY.
Power steering torque sensor
Refer to STEERING GEAR ASSEMBLY.
ECM
Transmits mainly the foll ...
Fuel Injector Offset Learning
Description
Fuel injector offset learning is an operation to allow ECM to learn
fuel injector offset data. This operation must be performed after the
following parts are replaced:
Each time injector or ECM is replaced.
(For details, refer to Work Procedure.)
Work Procedure
PRECONDITIONI ...
Safety and Health
Precautions for Operation
Precautions for Operation
In body repair, great importance is attached to quality, efficiency
and cost. Consideration for workers' safety and health should, however,
be deemed as the most important item. In reality, it is essential that
measures be established to ...
