Nissan Rogue manuals

Nissan Rogue Service Manual: The light reminder warning does not sound

Description

Light reminder warning does not sound even though headlamp is illuminated.

Diagnosis Procedure

1.CHECK COMBINATION METER INPUT SIGNAL

Select the "Data Monitor" for the "METER/M&A" and check the "BUZZER" monitor value.

Check combination meter input signal

Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-82, "Removal and Installation".

NO >> GO TO 2.

2.CHECK FRONT DOOR SWITCH LH SIGNAL CIRCUIT

Check the front door switch LH signal circuit. Refer to DLK-149, "Diagnosis Procedure" (with Intelligent Key system) or DLK-319, "Diagnosis Procedure" (without Intelligent Key system).

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace harness or connector.

3.CHECK FRONT DOOR SWITCH LH

Check the front door switch LH. Refer to DLK-150, "Component Inspection" (with Intelligent Key system) or DLK-320, "Component Inspection" (without Intelligent Key system).

Is the inspection result normal? YES >> Replace the BCM. Refer to BCS-75, "Removal and Installation" (with Intelligent Key system) or BCS-135, "Removal and Installation" (without Intelligent Key system).

NO >> Replace the front door switch LH. Refer to DLK-269, "Removal and Installation" (with Intelligent Key system) or DLK-385, "Removal and Installation" (without Intelligent Key system).

The seat belt reminder warning continues sounding, or does not sound
Description Seat belt warning does not sound even though driver seat belt is not fastened.  Seat belt warning sounds even though driver seat belt is fastened. Diagnosis Procedure 1.C ...

The key warning does not sound (without intelligent key)
Description The key warning chime does not sound, when all of the following conditions are fulfilled:  Key inserted into the key cylinder (key switch signal ON).  Ignition switch is ...

Other materials:

U1044 ENG comm circuit
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition U1044 ENG COMM CIRCUIT (Engine communication circuit A signal voltage of LIN communication between ECM and generator is excessively low or e ...

Towing a trailer
General information If the trailer socket is occupied, some driver assistance systems are unavailable, or available to a limited extent. A Check Control message is displayed where applicable. When driving with a trailer or load carrier and the trailer socket not occupied, some driver assistance sys ...

C1105, C1106, C1107, C1108 wheel sensor
DTC Logic DTC DETECTION LOGIC DTC Display Item Malfunction detected condition Possible causes C1105 RR RH SENSOR-2 When distance between rear wheel sensor RH and rear wheel sensor RH rotor is large.  When installation of rear whe ...

В© 2014-2023 Copyright www.nirogue.com