Nissan Rogue (T33) 2021-Present Service Manual: Symptom Diagnosis :: Vehicle Security System Cannot Be Set

Intelligent Key

Description

Armed phase is not activated when door is locked using Intelligent Key.

Diagnosis Procedure

CHECK INTELLIGENT KEY SYSTEM (REMOTE KEYLESS ENTRY FUNCTION)

Press the LOCK button of Intelligent Key.

Are all doors LOCKED?

YES>>

GO TO 2.

NO>>

Check Intelligent Key system (remote keyless entry function). Refer to System Description.

CHECK HOOD SWITCH

Check hood switch. Refer to Component Function Check.

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Replace hood lock assembly. Refer to Removal and Installation.

REPLACE BCM

Replace BCM. Refer to Removal and Installation.

Is the inspection result normal?

YES>>

Inspection End.

NO>>

Check intermittent incident. Refer to Intermittent Incident.

Door Request Switch

Description

Armed phase is not activated when door is locked using door request switch.

Diagnosis Procedure

CHECK INTELLIGENT KEY SYSTEM (DOOR LOCK FUNCTION)

Lock/unlock door with door request switch. Refer to System Description.

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Check Intelligent Key system (door lock function). Refer to Diagnosis Procedure.

CHECK HOOD SWITCH

Check hood switch. Refer to Component Function Check.

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Replace hood lock assembly. Refer to Removal and Installation.

REPLACE BCM

Replace BCM. Refer to Removal and Installation.

Is the inspection result normal?

YES>>

Inspection End.

NO>>

Check intermittent incident. Refer to Intermittent Incident.

    Symptom Diagnosis. Engine Does Not Start When Intelligent Key Is Inside of Vehicle (one Key)
    Description Engine does not start when push-button ignition switch is pressed. (One Intelligent Key has the symptom, other keys operate normally.)SYMPTOM TABLE (ONE INTELLIGENT ...
    Symptom Diagnosis. Vehicle Security Alarm Does Not Activate
    Description Alarm does not operate when alarm operating condition is satisfied. Diagnosis Procedure CHECK DOOR SWITCH Check door switch. Refer to Component Function Check. Is th...

    Other materials:

    How to Use This Manual. How to Read Wiring Diagrams
    Connector Symbols Most of connector symbols in wiring diagrams are shown from the terminal side. Connector symbols shown from the terminal side are enclosed by a single line and followed by the direction mark. Connector symbols shown from the harness side are enclosed by a double line and ...

    B2e49-06 Remote Actuator
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B2E49–06 Remote actuator not activated (Remote actuator not activated) Diagnosis condition When receiving remote command Signal (terminal) — Thresh ...

    Symptom Diagnosis. Wiper and Washer System Symptoms
    Symptom Table (Without Rain and Light Sensor) NOTE: Perform the "Self diagnosis result" with CONSULT before the symptom diagnosis. Perform the trouble diagnosis if any DTC is detected. Symptom Possible cause Inspection item Front wiper does not operate HI only BCM IPDM E ...