Nissan Rogue (T33) 2021-Present Service Manual: Symptom Diagnosis :: Driver Side Power Window Does Not Operate
Diagnosis Procedure
CHECK POWER WINDOW MAIN SWITCH POWER SUPPLY AND GROUND CIRCUIT
Check power window main switch power supply and ground circuit.
Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Repair or replace the malfunctioning parts.
CHECK FRONT POWER WINDOW MOTOR (DRIVER SIDE) POWER SUPPLY AND GROUND CIRCUIT
Check front power window motor (driver side) power supply and ground circuit.
Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>GO TO 3 .
NO>>Repair or replace the malfunctioning parts.
CHECK LIN COMMUNICATION CIRCUIT
Check LIN communication circuit.
Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>GO TO 4.
NO>>Repair or replace the malfunctioning parts.
CHECK POWER WINDOW MAIN SWITCH CIRCUIT
Check power window main switch circuit.
Refer to Component Function Check.
Is the inspection result normal?
YES>>GO TO 5.
NO>>Repair or replace the malfunctioning parts.
REPLACE POWER WINDOW MAIN SWITCH
-
Replace power window main switch. Refer to Removal and Installation.
-
Confirm the operation again.
Is the inspection result normal?
YES>>Inspection End.
NO>>Replace front power window motor (driver side). Refer to Disassembly and Assembly.
Other materials:
Differential Side Oil Seal
Exploded View
1.
Transaxle assembly
2.
Differential side oil seal (left side)
3.
Differential side oil seal (right side)
: Always replace after every disassembly.
: Apply CVT fluid.
1.
Transaxle assembly
2.
Differential side oil seal (left side)
  ...
C1f02-16 Power Supply Circuit
Without Propilot Assist 2.1
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
C1F02
16
POWER SUPPLY CIR
(Power supply circuit)
Diagnosis condition
When engine is running
When AEB system is ON
...
Ptc Heater
Component Function Check
CHECK PTC HEATER OPERATION
Start the engine.
Operate front blower motor.
Operate temperature control dial to full hot position.
Check for warm air at discharge air outlet.
NOTE:
Engine must be cold.
Battery must be charged.
Is the i ...
