Nissan Rogue Service Manual: Preparation

Nissan Rogue Service Manual / Body exterior, doors, roof & vehicle security / Door & Lock / With intelligent key system / Preparation

Special Service Tool

The actual shapes of the tools may differ from those illustrated here.

Tool number (TechMate No.) Tool name		Description
— (J-39570) Chassis Ear		Locating the noise
— (J-50397) NISSAN Squeak and Rattle Kit		Repairing the cause of noise
— (J-43241) Remote Keyless Entry Tester		Used to test keyfobs
— (J-50190) Signal Tech II		Activate and display TPMS transmitter IDs Display tire pressure reported by the TPMS transmitter Read TPMS DTCs Register TPMS transmitter IDs Check Intelligent Key relative signal strength Confirm vehicle Intelligent Key antenna signal strength Compatible with future sensors Equipped with a display
KV48105501 (J-45295-A) Transmitter Activation Tool		Activate TPMS transmitter IDs Compatible with future sensors Equipped with a display (KV48105501 only)
— (J-46534) Trim Tool Set		Removing trim components

Commercial Service Tool

(TechMate No.) Tool name		Description
(J-39565) Engine Ear		Locating the noise
( — ) Power Tool		Loosening nuts, screws and bolts

Precaution

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONE ...

System description

COMPONENT PARTS POWER DOOR LOCK SYSTEM POWER DOOR LOCK SYSTEM : Component Parts Location No Component Function 1 BCM Controls the door lock system. Re ...

Other materials:

P0506 ISC system
Description The ECM controls the engine idle speed to a specified level through the fine adjustment of the air, which is let into the intake manifold, by operating the electric throttle control actuator. The operating of the throttle valve is varied to allow for optimum control of the engine ...

Interior light
Interior light When the ON switch 1 is pressed, the footwell lights (if so equipped), step lights (if so equipped), map lights and rear personal lights will automatically turn on and stay on for a period of time when: The doors are unlocked by the Intelligent Key, a key or the r ...

ID registration procedure
Description This procedure must be performed after replacement of a tire pressure sensor or BCM. Work Procedure TPMS ID registration can be performed using one of the following procedures: Transmitter Activation tool [KV48105501 (J-45295-A)] with CONSULT (preferred method) ...