Nissan Rogue manuals

Nissan Rogue Service Manual: Parking brake switch

Removal and Installation

REMOVAL

  1.  Remove the instrument lower panel LH. Refer to IP-22, "Removal and Installation".
  2.  Disconnect the harness connector from the parking brake switch. Refer to PB-7, "Exploded View".
  3.  Remove the screw and remove the parking brake switch. Refer to PB-7, "Exploded View".

INSTALLATION

Installation is in the reverse order of removal.

CAUTION: Replace the parking brake switch if it has been dropped or sustained an impact.

Adjust the parking brake cable if necessary. Refer to PB-4, "Inspection and Adjustment".

Parking brake rear cable
Removal and Installation REMOVAL  Remove the center console assembly. Refer to IP-18, "Removal and Installation".  Remove shift selector. Refer to TM-194, "Removal a ...

Parking brake shoe
Exploded View Back plate Parking brake shoe Brake strut  Return spring Spring Return spring to brake strut  Adjuster Toggle lever Anti-rattle pin : Apply PBC ...

Other materials:

Sunshade
Removal and Installation REMOVAL Remove the moonroof unit assembly. Refer to RF-53, "Removal and Installation". Place the moonroof unit assembly (1) on a flat surface upside down and remove sunshade (2) screws (A). Manually move sunshade motor (1) using suitable tool (2 ...

P0456 EVAP control system
DTC Description DTC DETECTION LOGIC This diagnosis detects leaks in the EVAP line between fuel tank and EVAP canister purge volume control solenoid valve, using the negative pressure caused by decrease of fuel temperature in the fuel tank after turning ignition switch OFF. If ECM judges t ...

C1160 DECEL G SEN SET
DTC Logic DTC DETECTION LOGIC DTC Display Item Malfunction detected condition Possible causes C1160 DECEL G SEN SET When calibration of yaw rate/side/decel G sensor is not complete. Yaw rate/side/decel G sensor  Harness or connector   ...

В© 2014-2025 Copyright www.nirogue.com