Nissan Rogue manuals

Nissan Rogue Service Manual: C1160 DECEL G SEN SET

DTC Logic

DTC DETECTION LOGIC

DTC Display Item Malfunction detected condition Possible causes
C1160 DECEL G SEN SET When calibration of yaw rate/side/decel G sensor is not complete.
  • Yaw rate/side/decel G sensor
  •  Harness or connector
  •  ABS actuator and electric unit (control unit)
  •  Decel G sensor calibration is not performed

DTC CONFIRMATION PROCEDURE

1.CHECK SELF-DIAGNOSTIC RESULT

With CONSULT.

  1.  Turn ignition switch OFF to ON.
  2.  Perform self-diagnostic result.

Is DTC C1160 detected? YES >> Proceed to diagnosis procedure. Refer to BRC-101, "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1.DECEL G SENSOR CALIBRATION

Perform decel G sensor calibration. Refer to BRC-72, "Work Procedure".

>> GO TO 2.

2.CHECK SELF-DIAGNOSTIC RESULT

With CONSULT.

Perform self-diagnostic result.

Is DTC C1160 detected? YES >> GO TO 3.

NO >> Inspection End.

3.CHECK YAW RATE/SIDE/DECEL G SENSOR SYSTEM

Check yaw rate/side/decel G sensor system. Refer to BRC-84, "Diagnosis Procedure".

Is the inspection result normal? YES >> Replace ABS actuator and electric unit (control unit). Refer to BRC-136, "Removal and Installation".

NO >> Repair or replace malfunctioning components.

C1155 brake fluid level switch
DTC Logic DTC DETECTION LOGIC DTC Display Item Malfunction detected condition Possible causes C1155 BR FLUID LEVEL LOW When brake fluid level low signal is detected ...

C1164, C1165 CV system
DTC Logic DTC Logic DTC Display Item Malfunction detected condition Possible causes C1164 CV 1 When a malfunction is detected in cut valve 1. Harness or co ...

Other materials:

Flexible seating
WARNING  Never allow anyone to ride in the cargo area or on the rear seats when they are in the fold-down position. In a collision, people riding in these areas without proper restraints are more likely to be seriously injured or killed.  Do not allow peo ...

Preparation
Special Service Tool Tool number (TechMate No.) Tool name Description — (J-46534) Trim Tool Set Removing trim components Commercial Service Tool (TechMate No.) Tool name Description ( — ) Power tool Loo ...

Ignition switch (if so equipped)
WARNING  Never remove or turn the key to the LOCK position while driving. The steering wheel will lock (for models with a steering lock mechanism). This may cause the driver to lose control of the vehicle and could result in serious vehicle damage or personal ...

© 2014-2025 Copyright www.nirogue.com