Nissan Rogue (T33) 2021-Present Service Manual: P3194 Icc System

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / P3194 Icc System

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
P3194 00

Cruise control communication

(Adaptive Cruise Control CAN wheel speed information unavailable or absent) 		Diagnosis condition Ignition switch ON
Signal CAN communication signal
Threshold Abnormalities in each of the wheel rotation sensor signals that is received from VDC unit detected.
Diagnosis delay time 2 seconds

POSSIBLE CAUSE

  • Harness or connectors (The CAN communication line is open or shorted.)

  • ABS actuator and electric unit (control unit)

FAIL-SAFE

Engine Control System

Cruise control (ProPILOT Assist 1.1/ProPILOT Assist 2.1) operation prohibited

Stop/Start System

Not applicable

DTC CONFIRMATION PROCEDURE

PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

  1. Ignition switch OFF and wait at least 10 seconds.

  2. Ignition switch ON.

  3. Ignition switch OFF and wait at least 10 seconds.

TEST CONDITION:

Before performing the following procedure, confirm that battery voltage is between more than 11 V at idle.

>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE

  1. Ignition switch ON and wait at least 2 seconds.

  2. Check DTC.

Is DTC detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

PERFORM VDC DIAGNOSIS

Perform VDC diagnosis. Refer to DTC Index.

Is DTC detected?

YES>>

VDC repair performed first.

NO>>

GO TO 2.

CHECK CAN COMMUNICATION CIRCUIT

Perform the trouble diagnosis for CAN communication system. Refer to Trouble Diagnosis Flow Chart.

Is the inspection result normal?

YES>>

Check intermittent incident. Rerer to Intermittent Incident.

NO>>

Repair or replace damaged parts.

    P2dfd Purge Pump Performance
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition P2DFD 00 EVAP system purge pump (EVAP system purge pump) A D...
    P34ac Electric Intake Valve Timing Control Actuator
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P34AC 00 A camshaft posi actuator posi sens B1 (A Camshaft Posit...

    Other materials:

    Dtc/circuit Diagnosis. Power Supply and Ground Circuit. Sonar Control Unit
    Sonar Control Unit Diagnosis Procedure CHECK FUSE Check that the following fuse is not blown (open). Power source Fuse No. Capacity ACC power supply #40 10 A Is the fuse blown (open)? YES>> Be sure to eliminate cause of malfunction before installing new fuse. NO>&g ...

    Head up Display Switch Signal Circuit
    Diagnosis Procedure CHECK HEAD UP DISPLAY SWITCH SIGNAL CIRCUIT Ignition switch OFF. Disconnect Head Up Display unit harness connector and Head Up Display switch harness connector. Check continuity between Head Up Display unit harness connector and Head Up Display main switch harness ...

    Charge Air Cooler Coolant Temperature Sensor
    Component Inspection CHECK CHARGE AIR COOLER (CAC) TEMPERATURE SENSOR Turn ignition switch OFF. Remove CAC coolant temperature sensor. Refer to Exploded View. Check the resistance between CAC coolant temperature sensor terminals under the following conditions. Charge air cooler tem ...