Nissan Rogue (T33) 2021-Present Service Manual: P14aa Charge Air Cooler Cooling Electric Water Pump

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / P14aa Charge Air Cooler Cooling Electric Water Pump

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
P14AA

Charge air cooler cooling electric W/P

(Charge air cooler cooling electric water pump) 		Diagnosis condition

  • Engine running at idle

  • Warm-up condition

  • Battery voltage: More than 11V
Signal (terminal) —
Threshold Pump response duty becomes 83 – 92% after maintaining 2 – 8% (pump side: under protection control)
Diagnosis delay time 8 – 12 seconds

POSSIBLE CAUSE

  • Charge air cooler (CAC) coolant leakage

  • CAC coolant is mixed in air.

  • Protection control is activated during pump idle running.

  • Charge air cooler electric water pump

FAIL-SAFE

Not applicable

DTC CONFIRMATION PROCEDURE

PRECONDITIONING

NOTE:

When DTC Confirmation Procedure has been preciously conducted, always perform the following before conducting the next test.

  1. Turn ignition switch OFF and wait at least 10 seconds.

  2. Turn ignition switch ON.

  3. Turn ignition switch OFF and wait at least 10 seconds.

>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE

NOTE:

Before performing this procedure, check that the battery voltage is more than 11 V during ignition switch ON.

  1. Start the engine and warm it up to the normal operating temperature.

  2. Wait at least 20 seconds.

  3. Check 1st trip DTC.

Is DTC P14AA detected?

YES>>

Proceed to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

CHECK COOLANT LEVEL

Check the coolant level at the charge air cooler (CAC) coolant reservoir tank. Refer to Inspection.

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

GO TO 2.

CHECK CAC COOLING SYSTEM FOR COOLANT LEAKAGE

Check CAC cooling system for coolant leakage. Refer to Inspection.

Is the inspection result normal?

YES-1>>

With CONSULT: Refill coolant until the specified range. Refer to Refilling. And then, GO TO 4.

YES-2>>

Without CONSULT: GO TO 3.

NO>>

Repair or replace error-detected parts.

PERFORM DTC CONFIRMATION PROCEDURE

  1. Erase DTC.

  2. Perform DTC confirmation procedure. Refer to DTC Description.

Is the DTC P14AA detected again?

YES>>

Replace charge air cooler electric water pump. Refer to Removal and Installation.

NO>>

INSPECTION END

COMPONENT FUNCTION CHECK

With CONSULT

  1. Start the engine.

  2. On CONSULT screen, select “ENGINE”>>“Active Test”>>“Charge air cooler cooling electric water pump”.

  3. Perform the test and check that the water pump 1 is activated.

Is the inspection result normal?

YES>>

INSPECTION END (Protection mode operation)

NO>>

Replace charge air cooler electric water pump. Refer to Removal and Installation.

    P14a9 Charge Air Cooler Cooling Electric Water Pump
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P14A9 Charge air cooler cooling electric W/P (Charge air cooler ...
    P14ac Charge Air Cooler Cooling Electric Water Pump
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P14AC Charge air cooler cooling electric W/P (Charge air cooler ...

    Other materials:

    Batterie
    Informations de base Si la batterie porte la mention « ne pas ouvrir », elle est sans entretien et le niveau d’électrolyte ne doit pas être contrôlé. Maintenez la batterie propre et sèche. Nettoyez-la à l’aide d’un mélange d’eau et de bicarbonate de soude. Assurez-vo ...

    P060a Ecm
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P060A 00 CONTROL MODULE (Internal control module monitoring processor performance) Diagnosis condition Engine running at idle Signal (terminal) — ...

    Comment utiliser le HUD (Affichage Tête Haute) de votre Nissan Rogue
    Informations de base et activation L’utilisation du système d’affichage tête haute (HUD) sur le Nissan Rogue est conçue pour être aussi simple qu'efficace. Pour activer cette technologie de projection laser, il vous suffit d'appuyer sur la commande dédiée "HUD" située sur le pannea ...