Nissan Rogue (T33) 2021-Present Service Manual: P1099 Humidity Temperature Sensor

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
P1099 00

Humidity temperature sensor

(Humidity temperature sensor Circuit/Open)
Diagnosis condition ―
Signal (terminal) Humidity temperature sensor signal
Threshold An excessively High/Low voltage from the Humidity temperature sensor (Mass air flow sensor) is sent to ECM
Diagnosis delay time ―

POSSIBLE CAUSE

  • Humidity temperature sensor (Mass air flow sensor)

FAIL-SAFE

Not applicable

DTC Confirmation Procedure

DTC Confirmation Procedure

If DTC Confirmation Procedure has previously conducted,alwaiys peiform the following procedure before conducting the next tesut.

  1. Turn ignition switch OFF and wait at least 10 seconds.

  2. Turn ignition switch ON.

  3. Turn ignition switch OFF and wait at least 10 seconds.

Is DTC is detected?

>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE

  1. Start engine and wait at least 30 seconds.

  2. Check DTC.

Is DTC detected?

YES>>

Proceed to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

REPLACE MASS AIR FLOW SENSOR

Replace Mass air flow sensor. Refer to Exploded View.

>>

INSPECTION END

    P1098 Humidity Temperature Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P1098 00 Humidity temperature sensor (Humidity temperature senso...
    P10c8 Internal Control Module Fuel Injector
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P10C8 00 Cylinder1 injector A (Cylinder1 injector A) Diagnosis c...

    Other materials:

    Side Radar (rear Left) (side Radar Rear Lh)
    C1e00-44 Control Unit DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition C1E00–44 Control unit (Control unit) Diagnosis condition When ignition switch is ON. Signal (terminal) - Threshold If sid ...

    Lane Change Assist
    Basic information Lane Change Assist is a feature of ProPILOT Assist 2.1 on the Nissan Rogue. Read the entire ProPILOT Assist section before using this system, including how to operate it and how to interpret the display. When ProPILOT Assist is active and the status indicator A is illuminated in ...

    U0074-00 Av Communication
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U0074-00 Control module comm Bus B Off (Control module communication bus B off) Diagnosis condition When ignition switch is ON Signal (terminal) AV communic ...