Nissan Rogue Service Manual: P0962 pressure control solenoid A

Nissan Rogue Service Manual / Transmission & driveline / Transaxle & Transmission / Dtc/circuit diagnosis / P0962 pressure control solenoid A

DTC Description

DTC DETECTION LOGIC

DTC	CONSULT screen terms (Trouble diagnosis content)	DTC detection condition
P0962	PC SOLENOID A (Pressure Control Solenoid A Control Circuit Low)	When all of the following conditions are satisfied and this state is maintained for 0.2 seconds: TCM power supply voltage: More than 11 V TCM judges that solenoid valve circuit is shorted to ground.

POSSIBLE CAUSE

Harness or connector (Line pressure solenoid valve circuit is shorted to ground)
Line pressure solenoid valve

FAIL-SAFE

Selector shock is large
Start is slow
Acceleration is slow
Lock-up is not performed

DTC CONFIRMATION PROCEDURE

1.PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

>> GO TO 2.

2.CHECK DTC DETECTION

Start the engine and wait for 5 seconds or more.
Check the first trip DTC.

Is “P0962” detected? YES >> Go to TM-157, "Diagnosis Procedure".

NO-1 >> To check malfunction symptom before repair: Refer to GI-41, "Intermittent Incident".

NO-2 >> Confirmation after repair: INSPECTION END

Diagnosis Procedure

1.CHECK CIRCUIT BETWEEN TCM AND CVT UNIT

Turn ignition switch OFF.
Disconnect TCM connector and CVT unit connector.
Check continuity between TCM harness connector terminal and ground.

Check circuit between tcm and cvt unit

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair or replace damaged parts.

2.CHECK CIRCUIT BETWEEN CVT UNIT AND GROUND

Check continuity between CVT unit harness connector terminal and ground.

Check circuit between CVT unit and ground

Is the inspection result normal? YES >> INSPECTION END

NO >> There is malfunction of line pressure solenoid valve. Replace transaxle assembly. Refer to TM- 220, "Removal and Installation".

P0890 TCM

DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0890 TCM (Transmission Control Module Power Relay ...

P0963 pressure control solenoid A

DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0963 PC SOLENOID A(Pressure Control Solenoid A Control C ...

Other materials:

Operation
AUTOMATIC SPEED CONTROL DEVICE (ASCD) AUTOMATIC SPEED CONTROL DEVICE (ASCD) : Switch Name and Function SWITCHES AND INDICATORS A On the combination meter B On the steering wheel 1 CRUISE indicator 2 SET indicator 3 CANCEL switch 4 ACCEL/RES switch 5 COAST/SET switch 6 ASCD MAIN sw ...

P0078 EVT control solenoid valve
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condit P0078 EX V/T ACT/CIRC-B1 (Exhaust valve control solenoid circuit bank 1) An improper voltage is sent to the ECM through exhaust valve timing co ...

Periodic maintenance
FRONT SUSPENSION ASSEMBLY Inspection COMPONENT Check the conditions (looseness, backlash) of each component. Verify the component conditions (wear, damage) are normal. Ball Joint Axial End Play Set front wheels in a straight-ahead position. Move axle side of transverse link, ...