Nissan Rogue (T33) 2021-Present Service Manual: P0560 Sub Starter & Generator
DTC Description
DTC DETECTION LOGIC
| DTC |
CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition | ||
| P0560 | 00 |
Sub starter & generator (Sub starter & generator) |
Diagnosis condition | Engine running at idle |
| Signal (terminal) | CAN communication signal | |||
| Threshold | The voltage value transmitted IPDM E/R and the battery voltage value measured by sub starter & generator are different of 0.8 V or more | |||
| Diagnosis delay time | 15 seconds or more | |||
POSSIBLE CAUSE
-
IPDM E/R
-
Sub starter & generator
-
CAN communication circuit
-
Harness or connectors (12V battery voltage circuits is open or short circuit)
FAIL-SAFE
Engine Control System
Not applicable
Stop/Start System
When a DTC is detected, the stop/start indicator lamp blinks slowly and the stop/start system operation is prohibited. When ECM detects error while operating the stop/start system, ECM restarts the engine.
DTC CONFIRMATION PROCEDURE
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
-
Start the engine and let it idle and wait for 15 second or more.
-
Perform “Self Diagnostic Result” mode of “ECM”.
Is DTC detected?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: Inspection end.
Diagnosis Procedure
CHECK CAN COMMUNICATION CIRCUIT
Perform the trouble diagnosis for CAN communication system. Refer to Trouble Diagnosis Flow Chart.
Is inspection result normal?
YES>>GO TO 2.
NO>>Repair or replace error-detected parts.
CHECK DTC WITH SUB STARTER & GENERATOR
Check DTC with sub starter & generator. Refer to CONSULT Function (SUB STARTER & GENERATOR).
Is DTC C1C91-17 detected?
YES>>GO TO 3.
NO>>Repair or replace error-detected parts.
CHECK SUB STARTER & GENERATOR CIRCIT
Check sub starter & generator circit. Refer to Diagnosis Procedure.
Is inspection result normal?
YES>>INSPECTION END
NO>>Repair or replace error-detected parts.
Other materials:
System
System Description
Chassis control to integrally control the driving system was adopted.
Chassis control module inputs the necessary information for control
from CAN communication and each switch and integrally controls each
system. Refer to the following table for systems controlled a ...
Rear Door Alert
The Rear Door Alert system helps remind the driver to check the rear seat(s) before leaving the Nissan Rogue. Under certain conditions, the system indicates that an object or passenger may still be in the rear seat.
The Rear Door Alert system is initially disabled.
The driver can enable the system ...
P0090 Frp System
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P0090
00
FUEL PUMP
(Fuel Pressure Regulator "A" Control Circuit/Open)
Diagnosis condition
Engine running at idle
Signal (terminal)
High pressure fuel p ...