Nissan Rogue (T33) 2021-Present Service Manual: P0183 Ftt Sensor

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / P0183 Ftt Sensor

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
P0183 00

FTT SEN/CIRCUIT

(Fuel temperature sensor ″A″ circuit high) 		Diagnosis condition Ignition switch ON
Signal (terminal) Fuel tank temperature sensor signal
Threshold An excessively high voltage from the FTT sensor is sent to ECM.
Diagnosis delay time —

POSSIBLE CAUSE

  • Harness or connectors (FTT sensor circuit is open or shorted.)

  • Fuel tank temperature sensor

FAIL-SAFE

Not applicable

DTC Confirmation Procedure

PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

  1. Turn ignition switch OFF and wait at least 10 seconds.

  2. Turn ignition switch ON.

  3. Turn ignition switch OFF and wait at least 10 seconds.

>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE

  1. Turn ignition switch ON and wait at least 5 seconds.

  2. Check 1st trip DTC.

Is 1st trip DTC detected?

YES>>

Proceed to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

CHECK FUEL TANK TEMPERATURE (FTT) SENSOR POWER SUPPLY

  1. Turn ignition switch OFF.

  2. Disconnect fuel level sensor unit and fuel pump harness connector.

  3. Turn ignition switch ON.

  4. Check the voltage between fuel level sensor unit and fuel pump harness connector and ground.

    + −

    Voltage

    (Approx.)
    Fuel level sensor unit and fuel pump
    Connector Terminal
    B100 8 Ground 5 V

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

GO TO 2.

CHECK FUEL TANK TEMPERATURE (FTT) SENSOR POWER SUPPLY CIRCUIT

  1. Turn ignition switch OFF.

  2. Disconnect ECM harness connector.

  3. Check the continuity between fuel level sensor unit and fuel pump harness connector and ECM harness connector.

    + − Continuity
    Fuel level sensor unit and fuel pump ECM
    Connector Terminal Connector Terminal
    B100 8 E21 136 Existed

  4. Also check harness for short to ground and to power.

Is the inspection result normal?

YES>>

Perform the trouble diagnosis for power supply circuit.

NO>>

Repair or replace error-detected parts.

CHECK FUEL TANK TEMPERATURE (FTT) SENSOR GROUND CIRCUIT

  1. Turn ignition switch OFF.

  2. Disconnect ECM connector.

  3. Check the continuity between fuel level sensor unit and fuel pump harness connector and ECM harness connector.

    + − Continuity
    Fuel level sensor unit and fuel pump ECM
    Connector Terminal Connector Terminal
    B100 7 E21 155 Existed

  4. Also check harness for short to power.

Is the inspection result normal?

YES>>

GO TO 4.

NO>>

Repair or replace error-detected parts.

CHECK FUEL TANK TEMPERATURE (FTT) SENSOR

Check the FTT sensor. Refer to Component Inspection.

Is the inspection result normal?

YES>>

Check intermittent incident. Refer to Intermittent Incident.

NO>>

Replace “fuel level sensor unit and fuel pump”. Refer to Exploded View.

    P0182 Ftt Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0182 00 FTT SEN/CIRCUIT (Fuel temperature sensor ″A″ circui...
    P0191 Frp Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0191 00 FRP SENSOR A (Fuel Rail Pressure Sensor Circuit Range/P...

    Other materials:

    Power Socket. Removal and Installation. Power Socket
    Power Socket Console Power Socket Removal and Installation REMOVALRemove switch panel. Refer to Removal and Installation. Press the power socket fixing pawls from the back of the switch panel to remove the power socket. : Pawl INSTALLATIONNote the following, and install in the reve ...

    B2730-13 Side Sensor [rl]
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition B2730-13 SIDE SENSOR [RL] (Side sensor [RL]) Diagnosis condition When ignition switch is ON Signal (terminal) Rear sonar sensor signal LH side Threshold H ...

    Dtc/circuit Diagnosis. B0010-11 Assist A/b Module
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition B0010-11 ASSIST A/B MODULE (Passenger Frontal Stage 1 Deployment Control) Diagnosis condition When ignition switch is ON. Signal (terminal) Passenger air ba ...