Nissan Rogue (T33) 2021-Present Service Manual: P00f5 Maf Sensor

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
P00F5 00

Humidity Sensor Circuit High

(Humidity Sensor Circuit High)
Diagnosis condition IGN ON
Signal (terminal) Humidity sensor signal
Threshold An excessively high humidity output from the humidity sensor is sent to ECM.
Diagnosis delay time 2 seconds

POSSIBLE CAUSE

  • Humidity sensor (Mass air flow sensor)

FAIL-SAFE

Not applicable

DTC Confirmation Procedure

DTC Confirmation Procedure

If DTC Confirmation Procedure has previously conducted,alwaiys peiform the following procedure before conducting the next tesut.

  1. Turn ignition switch OFF and wait at least 10 seconds.

  2. Turn ignition switch ON.

  3. Turn ignition switch OFF and wait at least 10 seconds.

Is DTC is detected?

>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE

  1. Start engine and wait at least 5 seconds.

  2. Check DTC.

Is DTC detected?

YES>>

Proceed to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

REPLACE MASS AIR FLOW SENSOR

Replace Mass air flow sensor. Refer to Exploded View.

>>

INSPECTION END

    P00f4 Maf Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P00F4 00 Humidity Sensor Circuit Low (Humidity Sensor Circuit Lo...
    P00fe Evap Control System
    DTC Description This diagnosis detects clogs in the EVAP line between fuel tank and EVAP canister purge volume control solenoid valve.ECM controls EVAP control system as below. ...

    Other materials:

    U224a-87 Can Comm Err (awd/4wd)
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U224A 87 CAN comm err (AWD/4WD) [Controller area network communication error (AWD/4WD control unit)] 1 Diagnosis condition When ignition switch is ON. ...

    Removal and Installation. Tire Pressure Sensor
    Exploded View Screw Tire pressure sensor Valve Valve core Valve cap : Comply with the assembly procedure when tightening. Refer to Removal and Installation. : N·m (kg-m, in-lb) : Always replace after every disassembly. Removal & Install ...

    Service Data and Specifications (sds)
    General Specifications BRAKE SYSTEMJAPAN PRODUCTION MODELS WITHOUT ProPILOT Assist 2.1Unit: mm (in) Front brake Cylinder bore diameter 60.33 (2.3752) Pad length × width × thickness 123.6 × 53.5 × 10.5 (4.87 × 2.106 × 0.413) Rotor outer diameter × thickness 296 × 26.0 ( ...