Nissan Rogue (T33) 2021-Present Owner’s Manual & User Guide: Maintenance requirement
Basic information
Some day-to-day and scheduled maintenance is essential to keep your vehicle, including the Nissan Rogue, in good mechanical condition and maintain proper emissions and engine performance.
It is the owner's responsibility to make sure that scheduled maintenance and general maintenance are performed.
As the vehicle owner, you are the key link ensuring your Nissan Rogue receives the proper maintenance care.
General maintenance
General maintenance includes items that should be checked during normal daily operation. They are crucial for proper vehicle operation. It is your responsibility to perform these procedures regularly as prescribed.
Performing general maintenance checks requires minimal mechanical knowledge and only a few common automotive tools.
These checks can be done by you, a qualified technician or, if you prefer, a NISSAN dealer.
Scheduled maintenance
The maintenance items listed in this section must be serviced at regular intervals. Under severe driving conditions, additional or more frequent maintenance of your Nissan Rogue may be required.
Where to go for service
If maintenance service is required or the vehicle shows signs of malfunction, have the systems inspected. Visiting a NISSAN dealer is recommended.
NISSAN technicians are well-trained, kept up-to-date through service bulletins, technical tips and training programs.
They are fully qualified to work on NISSAN vehicles before any work begins.
If your vehicle is involved in a collision, it is recommended that you ask your NISSAN dealer for the location of the nearest NISSAN Certified Collision Center, or visit http://collision.nissanusa.com.
You can be confident that a NISSAN dealer's service department will properly handle the maintenance needs of your Nissan Rogue.
Other materials:
Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT
PRE-TENSIONER”, used along with a front seat belt, helps to reduce the
risk or severity of injury to the driver and front passeng ...
Power Supply and Ground Circuit
Diagnosis Procedure
CHECK FUSIBLE LINK
Ignition switch OFF.
Check that the following fusible links are not blown (open):
Signal name Fusible link No. Capacity
Battery power supply
E
100A
D
100A
B
140A
Z
30A
Is the fusible link blown (open)?
...
How to Erase Permanent Dtc
Description
OUTLINEWhen a DTC is stored in control moduleWhen
a DTC is stored in control module and MIL is ON, a permanent DTC is
erased with MIL shutoff if the same malfunction is not detected after
performing the driving pattern for MIL shutoff three times in a raw. *1:
When the same mal ...
